How To Fix CKMLMV036 - The indicator for cycles was deselected

SAP Error Message - Details

• Message type: E = Error

• Message class: CKMLMV - Message class for quantity structure tool

• Message number: 036

• Message text: The indicator for cycles was deselected

What causes this issue?

You have set the automatic error management indicator for cycles with
threshold values differently from cycles with negative prices. However,
it must be the same in both cases.

System Response

The indicator is reset to the preset value, in other words, 'Cut all
connections' is not set.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CKMLMV036 - The indicator for cycles was deselected ?

  The SAP error message CKMLMV036, which states "The indicator for cycles was deselected," typically occurs in the context of Material Ledger (ML) and is related to the configuration of the Material Ledger in SAP. This error indicates that the system is expecting a cycle indicator to be selected for a particular material or valuation area, but it has been deselected.
  Cause:
  
  Configuration Issue: The cycle indicator for the Material Ledger may not be activated for the relevant material or valuation area.
  Material Master Settings: The material master record may not have the cycle indicator set correctly.
  Valuation Area Settings: The valuation area settings in the configuration may not allow for cycles, leading to this error.
  
  Solution:
  
  
  Check Material Master Record:
  
  Go to the material master record (transaction code MM03).
  Check the accounting view and ensure that the cycle indicator is set correctly.
  
  
  
  Review Material Ledger Configuration:
  
  Use transaction code SPRO to access the configuration settings.
  Navigate to Controlling -> Product Cost Controlling -> Material Ledger -> Activate Material Ledger.
  Ensure that the cycle indicator is activated for the relevant valuation area.
  
  
  
  Adjust Valuation Area Settings:
  
  If the valuation area does not support cycles, you may need to adjust the settings or consult with your SAP configuration team to enable cycles for that area.
  
  
  
  Reprocess the Document:
  
  After making the necessary changes, reprocess the document that triggered the error to see if the issue is resolved.
  
  
  
  Related Information:
  
  
  Transaction Codes: 
  
  MM03 (Display Material Master)
  SPRO (SAP Reference IMG)
  CKMLCP (Material Ledger Closing)
  
  
  
  Documentation: Refer to SAP Help documentation for Material Ledger and Product Cost Controlling for detailed information on configuration and settings.
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or reach out to SAP support for further assistance.