How To Fix AH689 - Routine &1 include &2: parameter &3 not specified

SAP Error Message - Details

• Message type: E = Error

• Message class: AH - IS-U billing (master data)

• Message number: 689

• Message text: Routine &1 include &2: parameter &3 not specified

What causes this issue?

During conversion of units of measurement in a dimension, the system
established that not all required units of measurement have been
specified.

System Response

Processing is canceled.

How to fix this error?

Check whether one of the following causes applies:
The units of measurement for meter reading and for billing need to be
specified.
If gas billing is to occur, the units of measurement in the volume
correction factor procedure and the calorific value procedure also need
to be maintained. In each of these procedures the following units of
measurement should be the same, or at least fall within the same
dimensions.
Unit of measurement for meter reading and unit of measurement before
conversion of volume correction factor (such as M3)
Unit of measurment after conversion of volume correction factor and
unit of measurement before conversion of calorific value (such as NM3)
Unit of measurement after conversion of calorific value and unit of
measurement for billing (such as KWh)
If you do not find any errors here, the problem could be due to an
internal error. If this is the case, contact SAP.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message AH689 - Routine &1 include &2: parameter &3 not specified ?

  The SAP error message AH689 typically indicates that a required parameter is missing in a specific routine or include program. This error is often encountered during the execution of ABAP programs or when working with enhancements, user exits, or custom developments.
  
  Cause:
  The error message AH689 occurs when:
  
  A routine (function module, method, or include) is called without providing all the necessary parameters.
  The parameter specified in the error message (parameter &3) is expected by the routine but has not been supplied in the call.
  There may be a mismatch in the expected parameters due to changes in the routine or incorrect implementation of the calling program.
  
  
  Solution:
  To resolve the AH689 error, you can follow these steps:
  
  
  Check the Routine Definition: 
  
  Identify the routine (function module, method, or include) mentioned in the error message. 
  Review its definition to understand the parameters it requires.
  
  
  
  Review the Calling Code:
  
  Locate the code that calls the routine. Ensure that all required parameters