How To Fix ADPTM188 - Order w. relationship - Operation number must be unique in CMC (&1)

ADPTM188 - Overview

• Message type: E = Error

• Message class: ADPTM - Message Class for Component Maintenance Cockpit

• Message number: 188

• Message text: Order w. relationship - Operation number must be unique in CMC (&1)

What causes this issue?

The CMC has detected an order with relationships in which the operation
sequence is not equal to the operation number. The current error was
triggered, because the same operation number is used in more than one
of the linked orders. This is not permitted when linking orders. When
linking one order to another, the operation numbers within the grouping
must be unique.
<(>&<)>EXAMPLE<(>&<)>
Order A has operations 10 and 20. Order B has 20 and 30. This is not
permitted. A correct relationship would exist, when order A has
operations 10 and 20, and order B has 30 and 40 (linking operations 20
and 30).

System Response

Orders are treated seperately, but no CMC calculations are performed.

How to fix this error?

Correct the operation numbers within the relationship, so that the
operation numbers become unique within the group. When this is done,
the CMC will treat linked orders as one.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ADPTM188 - Order w. relationship - Operation number must be unique in CMC (&1) ?

  The SAP error message ADPTM188 indicates that there is an issue with the operation numbers in a production order or a related document in the Capacity Management (CMC) module. Specifically, it states that the operation number must be unique within the context of the order that has a relationship.
  
  Cause:
  The error typically arises due to one of the following reasons:
  
  Duplicate Operation Numbers: The same operation number is being used more than once within the same order or related orders. This can happen if operations are copied or if there is a mistake in manual entry.
  Incorrect Order Relationships: If there are relationships defined between orders (for example, dependent or predecessor/successor relationships), the operation numbers must be unique across these related orders.
  Data Integrity Issues: There may be inconsistencies in the data due to previous errors or incorrect configurations in the system.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Operation Numbers:
  
  Review the