How To Fix ADPTM186 - Order w. relationship - Only sequence type 'FS' allowed in CMC (&1)

ADPTM186 - Overview

• Message type: E = Error

• Message class: ADPTM - Message Class for Component Maintenance Cockpit

• Message number: 186

• Message text: Order w. relationship - Only sequence type 'FS' allowed in CMC (&1)

What causes this issue?

The CMC has detected an order with an operation sequence type different
to 'FS' (finish-start). The CMC can only handle orders with an
'FS'-relationship.

System Response

The orders are treated seperately, but no CMC calculations are
performed.

How to fix this error?

Correct the sequence type so that all the relationships have type
'FS'. Once this has been corrected, the CMC will treat orders that are
linked together as one.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ADPTM186 - Order w. relationship - Only sequence type 'FS' allowed in CMC (&1) ?

  The SAP error message ADPTM186 indicates that there is an issue with the relationship type defined for an order in the context of the CMC (Change Management Control) process. Specifically, it states that only the "Finish-to-Start" (FS) sequence type is allowed for the relationship in question.
  
  Cause:
  The error typically arises when:
  
  A relationship type other than FS (such as Start-to-Start (SS), Finish-to-Finish (FF), or Start-to-Finish (SF)) is being used in a scenario where only FS is permitted.
  The configuration or settings in the system do not allow for the specified relationship type due to business rules or system constraints.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Relationship Type: Review the order and its relationships in the CMC. Ensure that all relationships are set to "Finish-to-Start" (FS) as required by the system.
  
  
  Modify the Order Relationships:
  
  Navigate to the order in question.
  Access the relationships section.
  Change any non-FS relationships to FS.
  
  
  
  Review Configuration Settings: If