How To Fix XU029 - Qty convers. carried out for at least one alternativeUoM at mat.plan.val.

SAP Error Message - Details

• Message type: E = Error

• Message class: XU - Messages for Quantity Conversion at Batch Level (Steel-AI)

• Message number: 029

• Message text: Qty convers. carried out for at least one alternativeUoM at mat.plan.val.

What causes this issue?

During conversion between quantity stored and alternative quantities,
the batch-specific conversion ratio from classification was missing for
at least one alternative unit of measure.

System Response

Conversion was carried out for this unit of measure at the planned
conversion ratio at material level.

How to fix this error?

Check the units of measure where this error occurred, using the
Quantity conversion menu option. You can determine which
characteristics have not been valuated by displaying the
classification.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message XU029 - Qty convers. carried out for at least one alternativeUoM at mat.plan.val. ?

  The SAP error message XU029 indicates that there is an issue with quantity conversion for at least one alternative unit of measure (UoM) in the material planning valuation. This typically occurs when the system is unable to perform a quantity conversion due to missing or incorrect configuration in the material master data or the unit of measure settings.
  Cause:
  
  Missing Alternative UoM: The alternative unit of measure may not be defined in the material master.
  Incorrect Conversion Factors: The conversion factors between the base unit of measure and the alternative unit of measure may not be set up correctly.
  Material Master Data Issues: There may be inconsistencies or missing data in the material master record.
  Unit of Measure Settings: The settings for the unit of measure in the material master may not be properly configured.
  
  Solution:
  
  
  Check Material Master Data:
  
  Go to the material master record (transaction code MM03) and check the "Units of Measure" view.
  Ensure that the alternative unit of measure is defined and that the conversion factors are correctly set.
  
  
  
  Define Alternative UoM:
  
  If the alternative UoM is not defined, you can add it in the material master under the "Units of Measure" section.
  Make sure to specify the correct conversion factor relative to the base unit of measure.
  
  
  
  Review Conversion Factors:
  
  Verify that the conversion factors between the base unit of measure and the alternative unit of measure are accurate and make sense for the material.
  
  
  
  Check Configuration:
  
  Ensure that the configuration settings for units of measure in the system are correct. This can be done in the customizing settings (transaction code SPRO).
  
  
  
  Recheck Material Planning Settings:
  
  If the material is involved in planning, ensure that the planning settings are correctly configured to handle the alternative UoM.
  
  
  
  Test the Changes:
  
  After making the necessary changes, test the material planning process again to see if the error persists.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  MM03: Display Material Master
  MM02: Change Material Master
  SPRO: Customizing Implementation Guide
  
  
  
  Documentation: Refer to SAP Help documentation for detailed information on material master data and unit of measure settings.
  
  
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to this error message.
  
  
  By following these steps, you should be able to resolve the error message XU029 and ensure that quantity conversions for alternative units of measure are functioning correctly in your SAP system.