How To Fix XS015 - Device type & not allowed

SAP Error Message - Details

• Message type: E = Error

• Message class: XS - SAPconnect: All messages

• Message number: 015

• Message text: Device type & not allowed

What causes this issue?

Device type "&V1&" (see SAPscript/spool) is specified in the
configuration of node attributes. This device type is not defined in
spool administration.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

Processing was terminated.

How to fix this error?

Specify a valid device type for the node attributes or define "&V1&" in
spool administration.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message XS015 - Device type & not allowed ?

  The SAP error message XS015, which states "Device type & not allowed," typically occurs when there is an issue with the device type configuration in the SAP system. This error is often related to printing or output device settings.
  Cause:
  
  Invalid Device Type: The specified device type is not recognized or is not allowed for the particular output request.
  Authorization Issues: The user may not have the necessary authorizations to use the specified device type.
  Device Type Configuration: The device type may not be properly configured in the SAP system.
  Output Device Settings: The output device may not be set up correctly or may not be assigned to the user or the job.
  
  Solution:
  
  
  Check Device Type: Verify that the device type specified in the output request is valid and exists in the system. You can do this by checking the device type configuration in transaction SPAD (Spool Administration).
  
  
  Review Authorizations: Ensure that the user has the necessary authorizations to access the specified device type. This can be checked in transaction SU01 (User Maintenance) or by consulting with your security administrator.
  
  
  Configure Device Type: If the device type is not configured, you may need to create or modify it in transaction SPAD. Ensure that the device type is correctly defined and that it is allowed for the intended use.
  
  
  Check Output Device Settings: In transaction SPAD, check the settings for the output device being used. Ensure that it is correctly configured and that it is assigned to the appropriate user or job.
  
  
  Consult Documentation: If the issue persists, refer to SAP documentation or support resources for further troubleshooting steps specific to your SAP version and environment.
  
  
  Related Information:
  
  Transaction Codes: 
  
  SPAD: Spool Administration
  SU01: User Maintenance
  SP01: Spool Request Overview
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Forums: Consider searching SAP community forums or other user groups for similar issues and solutions shared by other users.
  
  If the problem continues after following these steps, it may be beneficial to contact your SAP support team for further assistance.