How To Fix WLC_PARALLEL001 - Syntax error &1 in generated report &4 in line &2 (&3)

SAP Error Message - Details

• Message type: E = Error

• Message class: WLC_PARALLEL - Load Distribution and External Parallel Processing

• Message number: 001

• Message text: Syntax error &1 in generated report &4 in line &2 (&3)

What causes this issue?

To control the parallel processing of the report, a main program (&V4&)
is generated. Syntax error &V1& occurred in line &V2& of this program.
The content of the line is: &V3&

System Response

The syntax check is the last step in program generation. The generated
report &V4& cannot be executed.

How to fix this error?

INCLUDE ISR_VERWALTUNG

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message WLC_PARALLEL001 - Syntax error &1 in generated report &4 in line &2 (&3) ?

  The SAP error message WLC_PARALLEL001 indicates a syntax error in a generated report. This error typically occurs when there is an issue with the code that has been generated for parallel processing in SAP. Here’s a breakdown of the components of the error message:
  
  &1: This usually represents the specific syntax error that has been detected.
  &2: This indicates the line number in the generated report where the error occurred.
  &3: This may provide additional context or information about the error.
  &4: This is the name of the generated report where the error was found.
  
  Causes
  
  Code Generation Issues: The report may have been generated incorrectly due to issues in the underlying data or configuration.
  Syntax Errors in Custom Code: If the report includes custom code, there may be syntax errors in that code.
  Incompatibility with Parallel Processing: The report may not be compatible with parallel processing, leading to syntax errors when the system attempts to execute it in parallel.
  Data Issues: Invalid or unexpected data being processed can lead to syntax errors during report generation.
  
  Solutions
  
  Check the Generated Code: Review the generated report code for any obvious syntax errors. You can do this by navigating to the report in the ABAP editor and checking the specified line number.
  Debugging: Use the debugging tools in SAP to step through the report execution and identify where the syntax error occurs.
  Review Custom Code: If the report includes custom ABAP code, ensure that it is syntactically correct and compatible with parallel processing.
  Adjust Parallel Processing Settings: If the report is not designed for parallel processing, consider adjusting the settings to run it in a single-threaded mode.
  Consult SAP Notes: Check the SAP Support Portal for any relevant notes or patches that may address this specific error.
  Test with Different Data: If the error is data-related, try running the report with different input data to see if the issue persists.
  
  Related Information
  
  SAP Documentation: Refer to the official SAP documentation for guidelines on writing and debugging ABAP code, especially in the context of parallel processing.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they found effective.
  Transaction Codes: Familiarize yourself with relevant transaction codes such as SE38 (ABAP Editor) and ST22 (Dump Analysis) for further investigation.
  
  If the issue persists after trying the above solutions, it may be beneficial to involve your SAP Basis or ABAP development team for deeper analysis and resolution.