How To Fix W_CB393 - No errors in test run setting User Status &1 for Condition Contract &2

SAP Error Message - Details

• Message type: E = Error

• Message class: W_CB -

• Message number: 393

• Message text: No errors in test run setting User Status &1 for Condition Contract &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message W_CB393 - No errors in test run setting User Status &1 for Condition Contract &2 ?

  Certainly! Here's a detailed explanation for the SAP error message:
  
  SAP Message:
  W_CB393 No errors in test run setting User Status &1 for Condition Contract &2
  
  1. Cause:
  This message is a warning (indicated by the "W" at the start of the message number) generated during a test run when setting a user status in a condition contract (often related to SAP Contract Management or Sales and Distribution).
  
  The system attempted to set a user status (&1) for a condition contract (&2).
  The test run did not find any errors or issues with this action.
  Essentially, this message informs you that the user status was successfully set in the test run, and no problems were detected.
  
  
  2. Meaning of the Message:
  
  User Status &1: This is the status you tried to set (e.g., "Released", "Blocked", "In Process").
  Condition Contract &2: This is the contract number or identifier where the status was applied.
  The message confirms that the status change can be applied without errors.
  
  
  3. Solution / Recommended Action:
  
  Since this is a warning indicating no errors, no corrective action is needed.
  You can proceed with the actual status change in the live environment.
  If you are running a test or simulation, this message confirms that the status change will succeed.
  
  
  4. Related Information:
  
  This message typically appears during status management in contract processing or condition contract maintenance.
  User statuses are used to control the processing and lifecycle of contracts.
  The test run is a simulation mode to check if status changes are valid without actually committing them.
  If you want to change the status for real, you should run the status change without the test flag.
  If you encounter errors in other scenarios, check the configuration of user statuses and status profiles in transaction BS02 (Change Status Profile) or BS03 (Display Status Profile).
  For more details on user status management, refer to SAP documentation on Status Management in Contract Management or Sales and Distribution.
  
  
  Summary:
  
  
  
  Aspect
  Description
  
  
  
  
  Message Type
  Warning (W)
  
  
  Cause
  Test run to set user status found no errors
  
  
  Effect
  Status change is valid and can be applied
  
  
  Solution
  No action needed; proceed with actual status change
  
  
  Related Tcodes
  BS02, BS03 (Status Profiles), VA43 (Display Contract)
  
  
  
  
  If you want, I can help you with the exact steps to change user status or troubleshoot related issues. Just let me know!