How To Fix VL058 - Conversion from & to & is not defined in Table T006

VL058 - Overview

• Message type: E = Error

• Message class: VL -

• Message number: 058

• Message text: Conversion from & to & is not defined in Table T006

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

VL058 - Details

• The SAP error message VL058, which states "Conversion from & to & is not defined in Table T006," typically occurs when there is an issue with the unit of measure (UoM) conversion in the SAP system. This error indicates that the system is unable to find a defined conversion factor between two units of measure in the T006 table, which is responsible for storing unit of measure definitions and their conversion factors.
  
  Cause:
  
  Missing Conversion Entry: The most common cause of this error is that there is no entry in the T006 table for the specific conversion between the two units of measure involved in the transaction.
  Incorrect Unit of Measure: The units of measure being used may not be valid or may not be set up correctly in the system.
  
  Configuration Issues: There may be configuration issues in the material master or in the settings related to units of measure.
  
  
  Solution:
  
  
  Check T006 Table: 
  
  Go