How To Fix V1110 - BOM explosion of item & had to be terminated

SAP Error Message - Details

• Message type: E = Error

• Message class: V1 - Verkaufsbelegbearbeitung

• Message number: 110

• Message text: BOM explosion of item & had to be terminated

What causes this issue?

During processing of item &V1&, BOM components should automatically be
entered in the sales document. However, one of the components could not
be entered.

System Response

Explosion of the bill of material was stopped at this component.

How to fix this error?

Check how the item has been exploded.
You should delete the item from the sales order. Once the problem has
been solved, you can still add the item to the order.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message V1110 - BOM explosion of item & had to be terminated ?

  The SAP error message V1110, which states "BOM explosion of item & had to be terminated," typically occurs during the process of bill of materials (BOM) explosion in the context of production planning or material requirements planning (MRP). This error indicates that the system encountered an issue while trying to explode the BOM for a specific item, leading to the termination of the process.
  Causes:
  
  Circular References: The BOM may contain circular references, where an item refers back to itself either directly or indirectly.
  Missing Components: One or more components in the BOM may be missing or not properly defined in the system.
  Incorrect BOM Structure: The BOM structure may be incorrectly configured, leading to inconsistencies.
  Data Inconsistencies: There may be inconsistencies in the master data, such as incorrect unit of measure or invalid material status.
  Excessive Depth: The BOM may be too deep or complex, exceeding system limits for processing.
  Configuration Issues: There may be issues with the configuration of the MRP or production planning settings.
  
  Solutions:
  
  Check BOM Structure: Review the BOM for the item in question to ensure that it is correctly structured and does not contain circular references.
  Validate Components: Ensure that all components listed in the BOM are valid and exist in the system. Check for any missing materials or incorrect material types.
  Review Master Data: Check the master data for the materials involved, including unit of measure, material status, and other relevant settings.
  Simplify BOM: If the BOM is too complex, consider simplifying it or breaking it down into smaller, manageable components.
  Check Configuration: Review the configuration settings for MRP and production planning to ensure they are set up correctly.
  Use Transaction Codes: Utilize transaction codes like CS03 (Display BOM) to analyze the BOM and identify any issues.
  Debugging: If the issue persists, consider debugging the process to identify the exact point of failure.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as CS01 (Create BOM), CS02 (Change BOM), and CS03 (Display BOM) for managing BOMs.
  SAP Notes: Check SAP Notes for any known issues or patches related to BOM processing that may address the error.
  Documentation: Refer to SAP documentation for best practices in BOM management and MRP configuration.
  Support: If the issue cannot be resolved internally, consider reaching out to SAP support for assistance.
  
  By following these steps, you should be able to identify the cause of the V1110 error and implement a solution to resolve it.