How To Fix UPX_KPI266 - Line &1: Number of decimal places has been reduced to &2

SAP Error Message - Details

• Message type: E = Error

• Message class: UPX_KPI - CRM Planning Services Messages

• Message number: 266

• Message text: Line &1: Number of decimal places has been reduced to &2

What causes this issue?

You are not allowed to specify a value higher than the value in the
SEM-BPS layout taken as the basis.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UPX_KPI266 - Line &1: Number of decimal places has been reduced to &2 ?

  The SAP error message UPX_KPI266 indicates that the number of decimal places for a particular key performance indicator (KPI) has been reduced. This typically occurs in the context of SAP Analytics Cloud (SAC) or SAP BusinessObjects when dealing with KPIs that are being displayed or calculated.
  Cause:
  The error message UPX_KPI266 is triggered when the system detects that the number of decimal places specified for a KPI exceeds the maximum allowed or is not compatible with the data type being used. This can happen due to:
  
  Data Type Limitations: The underlying data type for the KPI may not support the specified number of decimal places.
  Configuration Settings: The settings in the KPI configuration may have been set incorrectly, leading to a mismatch in expected decimal places.
  Data Source Issues: The data source feeding into the KPI may have limitations or constraints that affect how decimal places are handled.
  
  Solution:
  To resolve the UPX_KPI266 error, you can take the following steps:
  
  
  Check KPI Configuration:
  
  Review the configuration settings for the KPI in question. Ensure that the number of decimal places specified is within the acceptable range for the data type being used.
  
  
  
  Adjust Decimal Places:
  
  If the KPI is set to display more decimal places than allowed, reduce the number of decimal places in the KPI settings to match the maximum supported by the data type.
  
  
  
  Review Data Source:
  
  Investigate the data source for the KPI. Ensure that the data being pulled into the KPI is formatted correctly and does not have any constraints that would limit decimal places.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidelines on decimal places for KPIs in your version of SAP. This can provide insights into any limitations or best practices.
  
  
  
  Testing:
  
  After making adjustments, test the KPI to ensure that it displays correctly without triggering the error message.
  
  
  
  Related Information:
  
  SAP Notes and Knowledge Base Articles: Check for any relevant SAP Notes or KBA that might address this specific error or provide additional context.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  Version-Specific Behavior: Be aware that behavior may vary between different versions of SAP products, so ensure that you are looking at the correct version documentation.
  
  By following these steps, you should be able to address the UPX_KPI266 error and ensure that your KPIs are displayed correctly with the appropriate number of decimal places.