How To Fix UMG406 - Report cannot be executed. Status of CU&&UC procedure cannot be found.

SAP Error Message - Details

• Message type: E = Error

• Message class: UMG - Message Class for the Unicode Migration Tool.

• Message number: 406

• Message text: Report cannot be executed. Status of CU&&UC procedure cannot be found.

What causes this issue?

You execute the report UM4_FINISH_PREPARATION or UMG_FINISH_PREPARATION
which is used to finish the preparation for a Unicode conversion in a
Combined Upgrade & Unicode Conversion scenario (CU<(>&<)>UC).
The execution is not allowed because the release information stored in
table UM4STATUS is not available.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

if you are not conducting a CU<(>&<)>UC procedure you do not need to
execute report UM4_FINISH_PREPARATION or UMG_FINISH_PREPARATION
if you are conducting a CU<(>&<)>UC procedure and the table UM4STATUS is
empty you should check that all phases in the Upgrade finished without
error. Table UM4STATUS contains the most important steps of the
preparation for the a Unicode conversion

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UMG406 - Report cannot be executed. Status of CU&&UC procedure cannot be found. ?

  The SAP error message UMG406, which states "Report cannot be executed. Status of CU&&UC procedure cannot be found," typically occurs in the context of SAP's User Management Engine (UME) or when dealing with user management and authorization issues. This error indicates that the system is unable to find the status of a specific procedure, which can be due to various reasons.
  Causes:
  
  Missing or Incomplete Configuration: The CU&&UC procedure may not be properly configured or may be missing in the system.
  Database Issues: There could be issues with the database where the status of the procedure is stored, such as corruption or missing entries.
  Authorization Issues: The user executing the report may not have the necessary authorizations to access the CU&&UC procedure.
  System Updates or Changes: Recent updates or changes to the system may have affected the configuration or availability of the procedure.
  Transport Issues: If the procedure was transported from another system, it may not have been transported correctly.
  
  Solutions:
  
  Check Configuration: Verify that the CU&&UC procedure is correctly configured in the system. This may involve checking the relevant settings in the User Management Engine.
  Database Consistency Check: Perform a consistency check on the database to ensure that all necessary entries for the CU&&UC procedure exist and are not corrupted.
  Authorization Check: Ensure that the user executing the report has the necessary authorizations. You may need to check roles and profiles assigned to the user.
  Review System Logs: Check the system logs (transaction SLG1) for any additional error messages or warnings that may provide more context about the issue.
  Re-transport the Procedure: If the procedure was recently transported, consider re-transporting it to ensure that all necessary components are included.
  Consult SAP Notes: Look for relevant SAP Notes that may address this specific error message. SAP frequently updates its knowledge base with solutions for known issues.
  
  Related Information:
  
  SAP Documentation: Refer to the official SAP documentation for User Management Engine and related components for detailed configuration steps.
  SAP Community: Engage with the SAP Community forums where other users may have encountered similar issues and can provide insights or solutions.
  Support Tickets: If the issue persists, consider opening a support ticket with SAP for further assistance.
  
  By following these steps, you should be able to diagnose and resolve the UMG406 error in your SAP system.