How To Fix UCM0081 - No role is assigned to characteristic &2 of data stream &3

UCM0081 - Overview

• Message type: E = Error

• Message class: UCM0 - Messages for Data Basis, Cons Area, ...

• Message number: 081

• Message text: No role is assigned to characteristic &2 of data stream &3

What causes this issue?

Characteristic &V2& is contained in data stream &V3& of
<DS:GLOS.3C14A7065A82D511B1250008C784EFB1>data basis</> &V1&. However,
this characteristic does not yet have a role assignment. Therefore, it
cannot be used in the consolidation system.

System Response

The definition of the data basis is incomplete.

How to fix this error?

Check whether characteristic &V2& should be contained in data stream
&V3&.
If it should, assign a role to the characteristic, or go to the
definition of the
<DS:GLOS.E00981DCB529D51188040090273D34CB>InfoProvider</> in BW and use
the InfoObject that is intended for the desired role.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UCM0081 - No role is assigned to characteristic &2 of data stream &3 ?

  The SAP error message UCM0081 indicates that there is no role assigned to a characteristic in a data stream. This typically occurs in the context of SAP's Unified Change Management (UCM) or similar modules where data streams and characteristics are used to manage data effectively.
  
  Cause:
  The error arises when:
  
  A characteristic (identified by &2) in a specific data stream (identified by &3) does not have an associated role.
  This can happen if the characteristic was created but not properly configured with the necessary roles, or if the roles were removed or not assigned during the setup process.
  
  
  Solution:
  To resolve the UCM0081 error, you can follow these steps:
  
  
  Check Characteristic Configuration:
  
  Navigate to the configuration settings for the data stream in question.
  Verify that the characteristic identified by &2 is correctly defined.
  
  
  
  Assign Roles:
  
  Go to the role assignment section for the characteristic.
  Ensure that the appropriate roles are assigned to the characteristic. This may involve:
  Creating new roles if necessary.
  Assigning existing