How To Fix U6103 - Global indicator &1 does not match indicator in &2

SAP Error Message - Details

• Message type: E = Error

• Message class: U6 - Message Class for BRE

• Message number: 103

• Message text: Global indicator &1 does not match indicator in &2

What causes this issue?

Global indicator &V1& does <ZH>not</> match the corresponding indicator
in the table for &V2&.
ALL indicators are set to 'repaired' in &V2&. However, global indicator
&V1& has not been set.
Normally, the BRE sets this indicator.
Do not make any changes unless you want to trigger or prevent processing
via the BRE.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check &V1& and &V2&.
Note that the BRE reprocesses this case (maybe unnecessarily) until it
can set the global indicator.
<ZH>Note, also that the BRE only IGNORES entries that are proposed, but
not confirmed. </>

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message U6103 - Global indicator &1 does not match indicator in &2 ?

  The SAP error message U6103, which states "Global indicator &1 does not match indicator in &2," typically occurs in the context of data consistency checks within the SAP system. This error is often related to the configuration of global indicators in the system, which are used to control various functionalities and settings across different modules.
  Cause:
  The error arises when there is a mismatch between the global indicator set in one area of the system and the expected indicator in another area. This can happen due to several reasons, including:
  
  Configuration Changes: If there have been recent changes to the configuration settings in the system, it may lead to inconsistencies between different modules or components.
  Data Migration Issues: During data migration or system upgrades, if the global indicators are not correctly aligned, this error can occur.
  Custom Development: Custom programs or enhancements that manipulate global indicators may inadvertently cause mismatches.
  
  Solution:
  To resolve the U6103 error, you can follow these steps:
  
  
  Check Configuration Settings: Review the configuration settings for the global indicators in both areas referenced in the error message. Ensure that they are consistent and correctly set according to your business requirements.
  
  
  Synchronize Indicators: If you identify a mismatch, update the global indicator in one of the areas to match the other. This may involve changing settings in the configuration or adjusting the relevant master data.
  
  
  Review Recent Changes: If the error appeared after recent changes, review those changes to identify any potential causes. Reverting or correcting those changes may resolve the issue.
  
  
  Consult Documentation: Refer to SAP documentation or notes related to the specific modules involved. There may be specific guidelines or known issues that can provide further insight.
  
  
  Check for Custom Code: If there are custom developments in your system, review the code to ensure that it is not causing the mismatch. Debugging the custom code may help identify the root cause.
  
  
  Contact SAP Support: If the issue persists and you cannot identify the cause, consider reaching out to SAP support for assistance. They can provide more detailed guidance based on your specific system configuration.
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO (for configuration) or SE80 (for custom development) to investigate the issue further.
  SAP Notes: Search for relevant SAP Notes in the SAP Support Portal that may address this specific error or provide additional troubleshooting steps.
  Testing: After making changes, conduct thorough testing to ensure that the resolution does not introduce new issues.
  
  By following these steps, you should be able to identify and resolve the cause of the U6103 error in your SAP system.