How To Fix TPM_TRG026 - Single-level rate valuation procedure &2 does not exist (see long text)

TPM_TRG026 - Overview

• Message type: E = Error

• Message class: TPM_TRG - Treasury Position Management: Cross-Package Messages

• Message number: 026

• Message text: Single-level rate valuation procedure &2 does not exist (see long text)

What causes this issue?

A 'single-level rate valuation' step is set up in position management
procedure &V1&. However, the procedure &V2& set up for this step is not
defined as a single-level rate valuation procedure in Customizing.

System Response

The activity is terminated.

How to fix this error?

Remove the step 'single-level rate valuation' from the position
management procedure &V1& or save a defined single-level rate valuation
procedure.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message TPM_TRG026 - Single-level rate valuation procedure &2 does not exist (see long text) ?

  The SAP error message TPM_TRG026 indicates that a single-level rate valuation procedure specified in the system does not exist. This error typically arises in the context of Treasury and Risk Management (TRM) when dealing with financial instruments and their valuation.
  
  Cause:
  The error can occur due to several reasons:
  
  Missing Configuration: The single-level rate valuation procedure has not been defined in the system.
  Incorrect Settings: The valuation procedure might be incorrectly referenced in the transaction or configuration.
  Transport Issues: If the configuration was transported from another system, it might not have been included or activated properly.
  Version Mismatch: The system might be using an outdated or incompatible version of the valuation procedure.
  
  
  Solution:
  To resolve the TPM_TRG026 error, you can follow these steps:
  
  
  Check Configuration:
  
  Go to the configuration settings for Treasury and Risk Management.
  Navigate to the section where valuation procedures are defined (usually under Financial Instruments).
  Verify if the single-level rate valuation procedure you are trying to use is defined