How To Fix /SAPAPO/SOR106 - RSG &2 (from entry location prod.) was selected for entry loc. &1

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/SOR -

• Message number: 106

• Message text: RSG &2 (from entry location prod.) was selected for entry loc. &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/SOR106 - RSG &2 (from entry location prod.) was selected for entry loc. &1 ?

  The SAP error message /SAPAPO/SOR106 typically occurs in the context of SAP Advanced Planning and Optimization (APO) when there is an issue with the selection of a resource or location in the planning process. The message indicates that a specific resource (RSG) was selected for an entry location, but there may be a mismatch or an issue with the configuration or data.
  Cause:
  
  Resource Configuration: The resource (RSG) may not be properly configured for the entry location (&1). This could be due to missing assignments or incorrect settings in the resource master data.
  Location Assignment: The entry location may not be assigned to the resource group or may not be valid for the selected resource.
  Planning Version: The planning version being used may not have the correct data or settings for the resource and location.
  Data Inconsistency: There may be inconsistencies in the master data or transactional data that lead to this error.
  
  Solution:
  
  Check Resource Configuration: Verify that the resource (RSG) is correctly configured for the entry location (&1). Ensure that the resource is assigned to the correct location in the resource master data.
  Review Location Assignment: Ensure that the entry location is properly assigned to the resource group. You can check this in the resource master data settings.
  Validate Planning Version: Make sure that the planning version you are using has the correct settings and data for the resource and location. If necessary, switch to a different planning version that is correctly configured.
  Data Consistency Check: Perform a consistency check on the master data and transactional data to identify any discrepancies. You may need to run reports or use transaction codes to validate the data.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the error message and related configuration settings.
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like /SAPAPO/RSC1 (for resource master data) or /SAPAPO/LOC1 (for location master data) to check and modify the relevant settings.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide additional troubleshooting steps.
  Support: If the issue persists, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.