How To Fix /SAPAPO/RRP787 - Number of pegging areas with planning termination: &1

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/RRP -

• Message number: 787

• Message text: Number of pegging areas with planning termination: &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/RRP787 - Number of pegging areas with planning termination: &1 ?

  The SAP error message /SAPAPO/RRP787 indicates that there are too many pegging areas with planning termination in the Advanced Planning and Optimization (APO) module. This typically occurs during the planning process when the system encounters a situation where it cannot continue due to the number of pegging areas that have reached a planning termination state.
  Cause:
  
  Excessive Pegging Areas: The error is often caused by having too many pegging areas that are not being processed correctly, leading to a situation where the planning process cannot continue.
  Configuration Issues: There may be issues with the configuration of the planning areas or the way the pegging is set up in the system.
  Data Volume: A large volume of data being processed can also lead to this error, especially if the system is not optimized for handling such volumes.
  Planning Parameters: Incorrect or suboptimal planning parameters can lead to inefficient processing and result in planning terminations.
  
  Solution:
  
  Review Pegging Areas: Check the pegging areas that are causing the issue. You may need to analyze the data and see if there are any inconsistencies or errors in the pegging setup.
  Optimize Planning Parameters: Review and optimize the planning parameters in the APO system. This may involve adjusting the settings for the planning run to better handle the data volume.
  Reduce Data Volume: If possible, reduce the amount of data being processed in a single planning run. This can be done by breaking down the planning process into smaller chunks.
  Check Configuration: Ensure that the configuration of the planning areas and the pegging settings are correct. This may involve consulting with a functional consultant or SAP support.
  Monitor System Performance: Keep an eye on system performance during planning runs. If the system is consistently running into this error, it may be necessary to look into hardware or system resource upgrades.
  
  Related Information:
  
  Transaction Codes: You can use transaction codes like /SAPAPO/RRP3 to analyze the pegging areas and see where the issues might be occurring.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide guidance on best practices for managing pegging areas.
  Documentation: Refer to the SAP APO documentation for detailed information on pegging and planning processes, which can provide insights into how to configure and optimize your system.
  
  If the issue persists after trying the above solutions, it may be beneficial to reach out to SAP support for further assistance.