How To Fix /SAPAPO/OM_ERROR368 - Resource 'use_block_times' set in first or last block

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPAPO/OM_ERROR -

• Message number: 368

• Message text: Resource 'use_block_times' set in first or last block

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPAPO/OM_ERROR368 - Resource 'use_block_times' set in first or last block ?

  The SAP error message /SAPAPO/OM_ERROR368 indicates an issue related to the configuration of resource block times in the Advanced Planning and Optimization (APO) module. Specifically, the error states that the resource parameter use_block_times is set in either the first or last block of a resource, which is not allowed.
  Cause:
  The error typically arises when:
  
  The resource configuration in APO has been incorrectly set up, particularly regarding the block times.
  The use_block_times parameter is intended to define whether block times should be considered for scheduling, but it cannot be applied to the first or last block of a resource's scheduling profile.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Resource Configuration:
  
  Go to the resource master data in APO.
  Review the block time settings for the resource in question.
  Ensure that the use_block_times parameter is not set for the first or last block.
  
  
  
  Adjust Block Times:
  
  If the use_block_times is set for the first or last block, you will need to remove or adjust this setting.
  You may need to redefine the block times to ensure they are only applied to the appropriate blocks.
  
  
  
  Validate Changes:
  
  After making the necessary adjustments, validate the resource configuration.
  Run a test planning run to ensure that the error does not occur again.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for detailed information on resource configuration and block times.
  
  
  
  Seek Support:
  
  If the issue persists after making adjustments, consider reaching out to SAP support or consulting with an SAP APO expert for further assistance.
  
  
  
  Related Information:
  
  Block Times: These are periods of time that are added to the start or end of production runs to account for setup, teardown, or other non-productive times.
  Resource Master Data: This is where you define the characteristics and capabilities of resources used in production planning.
  APO Configuration: Proper configuration of resources is critical for effective planning and scheduling in SAP APO.
  
  By following these steps, you should be able to resolve the error and ensure that your resource configurations are set up correctly.