How To Fix RS2HANA_AUTH318 - Cleanup initially running in simulation mode

RS2HANA_AUTH318 - Overview

• Message type: E = Error

• Message class: RS2HANA_AUTH -

• Message number: 318

• Message text: Cleanup initially running in simulation mode

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message RS2HANA_AUTH318 - Cleanup initially running in simulation mode ?

  The SAP error message RS2HANA_AUTH318 indicates that the cleanup process for the HANA database is currently running in simulation mode. This means that the system is simulating the cleanup process without actually making any changes to the database. This is typically done to allow administrators to review what would happen during the actual cleanup without affecting the data.
  
  Cause:
  The primary cause of this message is that the cleanup job has been initiated in simulation mode. This can happen for several reasons:
  
  The job was explicitly started in simulation mode by the user.
  There may be a configuration setting that defaults the job to run in simulation mode.
  The user may not have the necessary authorizations to execute the cleanup in actual mode.
  
  
  Solution:
  To resolve this issue and run the cleanup process for real, you can follow these steps:
  
  
  Check Job Parameters: Review the parameters used to start the cleanup job. Ensure that it is not set