How To Fix RQ286 - The first &1 columns show historical values. Start date &2 correct?

SAP Error Message - Details

• Message type: E = Error

• Message class: RQ - Messages for Cash Management and Forecast

• Message number: 286

• Message text: The first &1 columns show historical values. Start date &2 correct?

What causes this issue?

In the subsequent out, the first &V1& columns display amounts in the
past.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check if the start date was entered correctly.
This message is displayed if the current date is not included in the
first two columns.
If the current date is not displayed in the first column, then the
message is not shown because the start date can be set to yesterday or
the last working day, in order to see the delta values for today and
then this message would not be required.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RQ286 - The first &1 columns show historical values. Start date &2 correct? ?

  The SAP error message RQ286 indicates that there is an issue with the historical values in a report or transaction, specifically related to the start date of a certain period. This error typically arises in the context of reporting or data entry where historical data is being analyzed or modified.
  Cause:
  
  Incorrect Start Date: The start date specified in the transaction or report may not align with the historical data being referenced. This can happen if the start date is set to a time before the historical data was recorded.
  Data Consistency Issues: There may be inconsistencies in the data that prevent the system from correctly interpreting the historical values.
  Configuration Issues: The configuration settings for the reporting or data entry process may not be set up correctly, leading to this error.
  
  Solution:
  
  Verify Start Date: Check the start date (&2) that you have entered. Ensure that it is correct and falls within the range of the historical data you are trying to access.
  Review Historical Data: Look at the historical values being referenced in the first &1 columns. Ensure that they are valid and that the data is consistent with the start date you are using.
  Adjust Configuration: If the issue persists, review the configuration settings related to the report or transaction. Ensure that they are set up to handle historical data correctly.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the transaction or report you are working with. There may be additional parameters or settings that need to be adjusted.
  Contact Support: If you are unable to resolve the issue, consider reaching out to your SAP support team or consulting with an SAP expert who can provide more tailored assistance.
  
  Related Information:
  
  Transaction Codes: Depending on the context of the error, you may be working with specific transaction codes related to reporting or data entry (e.g., CO, FI, MM).
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide additional troubleshooting steps.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the RQ286 error and implement a solution to resolve it.