How To Fix RPLM_RECORD_RESULTS019 - No inspection point: inspection point-specific selection was ignored

RPLM_RECORD_RESULTS019 - Overview

• Message type: E = Error

• Message class: RPLM_RECORD_RESULTS - Messages for Results Recording for Portal Role

• Message number: 019

• Message text: No inspection point: inspection point-specific selection was ignored

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message RPLM_RECORD_RESULTS019 - No inspection point: inspection point-specific selection was ignored ?

  The SAP error message RPLM_RECORD_RESULTS019 indicates that there is no inspection point available for the inspection lot you are trying to process. This error typically occurs in the context of quality management (QM) when recording results for inspection lots.
  
  Cause:
  
  No Inspection Points Defined: The inspection lot does not have any inspection points defined. This can happen if the inspection lot was created without specifying inspection points or if the inspection points were deleted or not generated correctly.
  Incorrect Inspection Lot Status: The inspection lot may be in a status that does not allow for inspection point processing.
  
  Configuration Issues: There may be issues with the configuration of the inspection plan or the material master that prevent inspection points from being generated.
  Selection Criteria: The selection criteria used to access the inspection points may not match any existing inspection points.
  
  
  Solution:
  
  Check Inspection Lot: Verify the inspection lot in question to see if it has any inspection