How To Fix RM840 - No entering of rework when subsequently posting previous reporting points

SAP Error Message - Details

• Message type: E = Error

• Message class: RM - Messages for Repetitive Manufacturing

• Message number: 840

• Message text: No entering of rework when subsequently posting previous reporting points

What causes this issue?

You want to enter rework and post the previous reporting points again
at the same time.

System Response

For technical reasons, these processes cannot be entered at the same
time.

How to fix this error?

First execute the subsequent posting of the previous reporting points
at the predecessor reporting point, and then enter the rework on the
current reporting point without posting subsequently.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RM840 - No entering of rework when subsequently posting previous reporting points ?

  The SAP error message RM840 ("No entering of rework when subsequently posting previous reporting points") typically occurs in the context of production orders or process orders when there is an attempt to post rework for a reporting point that has already been processed or closed. This error is related to the handling of production processes and the management of reporting points in SAP.
  Cause:
  
  Closed Reporting Points: The error usually arises when you try to enter rework for a reporting point that has already been completed or closed in the system.
  Incorrect Sequence of Operations: If the sequence of operations is not followed correctly, or if there are attempts to post to earlier reporting points after they have been finalized, this error can occur.
  Configuration Issues: There may be configuration settings in the production order or process order that prevent rework postings under certain conditions.
  
  Solution:
  
  Check Reporting Point Status: Verify the status of the reporting points in the production order. Ensure that you are not trying to post rework for a reporting point that has already been completed.
  Correct Posting Sequence: Ensure that you are following the correct sequence of operations. If you need to enter rework, it should be done for the current or next reporting point, not for previous ones.
  Review Order Configuration: Check the configuration settings for the production or process order. Ensure that the settings allow for rework postings as needed.
  Use the Correct Transaction: Make sure you are using the appropriate transaction code for posting rework. For example, use transaction codes like CO11N (for confirmation) or CO15 (for rework) as applicable.
  Consult Documentation: Refer to SAP documentation or help files for specific guidance on handling rework postings and reporting points.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on handling rework in production orders.
  User Exits and BAdIs: If your organization has custom enhancements, check if there are any user exits or BAdIs that might affect the behavior of rework postings.
  Training and Support: If you are unsure about the process, consider reaching out to your SAP support team or attending training sessions on production order management and reporting points.
  
  By following these steps, you should be able to resolve the RM840 error and successfully manage rework postings in your SAP environment.