How To Fix QS048 - Insp. by config. only allowed with a task list/material specification

SAP Error Message - Details

• Message type: E = Error

• Message class: QS - QM: Master data

• Message number: 048

• Message text: Insp. by config. only allowed with a task list/material specification

What causes this issue?

For inspection type &v1&, you have set the indicator "Inspect by
configuration". However, inspecting with a configuration is only
allowed if you inspect with a task list or with a material
specification.

System Response

How to fix this error?

If you want to inspect by configuration, set at least one of the
indicators "Inspect with task list" or "Inspect with material
specification".

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QS048 - Insp. by config. only allowed with a task list/material specification ?

  The SAP error message QS048 ("Insp. by config. only allowed with a task list/material specification") typically occurs in the context of Quality Management (QM) when you are trying to perform an inspection that is configured to use a task list or material specification, but the system cannot find the necessary configuration.
  Cause:
  
  Missing Task List or Material Specification: The error usually indicates that the inspection lot you are trying to create or process is configured to use a task list or material specification, but either of these is not defined or linked correctly in the system.
  Incorrect Configuration: The configuration settings for the inspection plan or material specification may not be set up correctly, leading to the system not being able to find the required data.
  Inspection Type Settings: The inspection type settings may not be aligned with the requirements for using a task list or material specification.
  
  Solution:
  
  
  Check Task List/Material Specification:
  
  Ensure that the task list or material specification is created and active in the system.
  Verify that the task list is assigned to the material in question.
  
  
  
  Review Inspection Plan:
  
  Go to the inspection plan associated with the material and check if it is correctly configured to use a task list or material specification.
  Ensure that the inspection plan is active and properly linked to the material master.
  
  
  
  Inspect Configuration Settings:
  
  Review the configuration settings in the Quality Management module to ensure that they are set up correctly for the inspection type you are using.
  Check the settings in transaction code SPRO under Quality Management to ensure that the relevant configurations are in place.
  
  
  
  Use Transaction Codes:
  
  Use transaction codes like QDP1 (Create Inspection Plan) or QDP2 (Change Inspection Plan) to verify and adjust the inspection plan settings.
  Use MM03 to check the material master data and ensure that the inspection type is correctly set.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on configuring inspection plans and task lists.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  User Roles and Authorizations: Ensure that the user has the necessary authorizations to create or modify inspection plans and task lists.
  Testing: After making changes, test the process again to ensure that the error is resolved.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in Quality Management for further assistance.