How To Fix QPCP088 - Inspection char. &1 from plan &2 links to a deleted FMEA characteristic

SAP Error Message - Details

• Message type: E = Error

• Message class: QPCP - Control Plan

• Message number: 088

• Message text: Inspection char. &1 from plan &2 links to a deleted FMEA characteristic

What causes this issue?

The plan contains an inspection characteristic that was deleted from the
FMEA.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Delete the inspection characteristic from the plan or set the
characteristic origin to initial.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QPCP088 - Inspection char. &1 from plan &2 links to a deleted FMEA characteristic ?

  The SAP error message QPCP088 indicates that there is an issue with an inspection characteristic in a quality management (QM) process. Specifically, it suggests that the inspection characteristic you are trying to use is linked to a Failure Mode and Effects Analysis (FMEA) characteristic that has been deleted. This can occur in scenarios where the FMEA is used to define inspection characteristics, and if the FMEA is modified or deleted, it can lead to inconsistencies in the related inspection plans.
  Cause:
  
  Deleted FMEA Characteristic: The primary cause of this error is that the inspection characteristic in the quality plan is referencing an FMEA characteristic that no longer exists.
  Data Inconsistency: Changes in the FMEA or inspection plan that were not properly synchronized can lead to this error.
  Configuration Issues: There may be issues with how the FMEA and inspection characteristics are configured in the system.
  
  Solution:
  
  
  Check FMEA Characteristics: Verify if the FMEA characteristic that the inspection characteristic is linked to has indeed been deleted. If it has been deleted, you will need to either restore it or update the inspection characteristic to link it to a valid FMEA characteristic.
  
  
  Update Inspection Plan: If the FMEA characteristic is no longer needed, you can update the inspection plan to remove the reference to the deleted characteristic. This can be done by:
  
  Navigating to the inspection plan in SAP.
  Editing the inspection characteristics and removing or replacing the link to the deleted FMEA characteristic.
  
  
  
  Recreate FMEA: If the FMEA characteristic is still relevant, consider recreating it in the system. Ensure that it is properly linked to the inspection characteristics in the quality plan.
  
  
  Data Consistency Check: Run a consistency check in the system to identify any other potential issues related to FMEA and inspection characteristics.
  
  
  Consult Documentation: Review SAP documentation or consult with your SAP support team for specific steps related to your version of SAP, as the process may vary slightly depending on the configuration.
  
  
  Related Information:
  
  FMEA in SAP: FMEA is a systematic method for evaluating processes to identify where and how they might fail and assessing the relative impact of different failures. It is often used in conjunction with quality management processes.
  Quality Management Module: Familiarize yourself with the QM module in SAP, as it encompasses various functionalities related to inspection planning, quality control, and FMEA.
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message. SAP frequently updates its system with fixes and improvements.
  
  By following these steps, you should be able to resolve the QPCP088 error and ensure that your inspection characteristics are correctly linked to valid FMEA characteristics.