How To Fix QP224 - Results Rec. by Insp. Unit: No Char. Without Indep. Multiple Samples (&)

SAP Error Message - Details

• Message type: E = Error

• Message class: QP - Message IDs for function module group QPAA

• Message number: 224

• Message text: Results Rec. by Insp. Unit: No Char. Without Indep. Multiple Samples (&)

What causes this issue?

You selected the view for <LS>recording units to be inspected</> for
the operation. The <LS>recording of units to be inspected</> is not
supported for characteristics with independent multiple samples.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Select another recording view for the operation.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QP224 - Results Rec. by Insp. Unit: No Char. Without Indep. Multiple Samples (&) ?

  The SAP error message QP224, which states "Results Rec. by Insp. Unit: No Char. Without Indep. Multiple Samples (&)," typically occurs in the context of quality management (QM) when dealing with inspection lots and characteristics in SAP.
  Cause:
  This error message indicates that there is an attempt to record results for an inspection lot that does not have any characteristics defined for independent multiple samples. In other words, the system is expecting certain characteristics to be present for the inspection unit, but they are missing or not configured correctly.
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Inspection Plan: 
  
  Ensure that the inspection plan associated with the inspection lot has the necessary characteristics defined. You can do this by navigating to the inspection plan in SAP and verifying that the characteristics are set up correctly.
  
  
  
  Review Inspection Lot:
  
  Check the inspection lot to see if it is correctly assigned to the inspection plan. You can do this by using transaction code QA32 or QA03 to display the inspection lot and its details.
  
  
  
  Define Characteristics:
  
  If the characteristics are missing, you may need to define them in the inspection plan. Go to the inspection plan and add the required characteristics that are needed for the inspection.
  
  
  
  Check Sampling Procedure:
  
  Ensure that the sampling procedure used in the inspection plan is appropriate for the type of inspection being performed. If the sampling procedure is not set up correctly, it may lead to this error.
  
  
  
  Use Correct Inspection Type:
  
  Make sure that the inspection type used for the inspection lot is appropriate for the characteristics you are trying to record. Different inspection types may have different requirements for characteristics.
  
  
  
  Consult Documentation:
  
  If you are unsure about the configuration or setup, refer to SAP documentation or consult with your SAP QM module expert for guidance on how to set up inspection plans and characteristics correctly.
  
  
  
  Related Information:
  
  
  Transaction Codes: 
  
  QA32 - Display Inspection Lot
  QA03 - Display Inspection Plan
  QP01 - Create Inspection Plan
  QP02 - Change Inspection Plan
  QP03 - Display Inspection Plan
  
  
  
  SAP Notes: 
  
  Check for any relevant SAP Notes that may address specific issues related to this error message. You can search for notes in the SAP Support Portal.
  
  
  
  Quality Management Configuration: 
  
  Familiarize yourself with the configuration settings in the Quality Management module, especially those related to inspection plans, characteristics, and sampling procedures.
  
  
  
  By following these steps, you should be able to identify the root cause of the error and implement the necessary changes to resolve it.