How To Fix QMIP_EA226 - Control indicators for &1 &2 allow for an upper specification limit

QMIP_EA226 - Overview

• Message type: E = Error

• Message class: QMIP_EA - QM: Inpection Planning - Insp. Plan and Master Insp. Chars

• Message number: 226

• Message text: Control indicators for &1 &2 allow for an upper specification limit

What causes this issue?

The control indicators from the master inspection characteristic and the
determined data from the specification characteristic are inconsistent.

System Response

The system adapts the control indicators of the task list characteristic
to the information from the master inspection characteristic.

How to fix this error?

Check the control indicators of the master inspection characteristic or
the mapping table for the value assignment type.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

QMIP_EA226 - Details

• The SAP error message QMIP_EA226 indicates that there is an issue with the control indicators for a specific characteristic in Quality Management (QM). This error typically arises when the system detects that the control indicators set for a characteristic do not allow for an upper specification limit (USL) to be defined or used.
  
  Cause:
  The error can occur due to several reasons:
  
  Control Indicator Settings: The control indicators assigned to the characteristic may not be configured to allow for upper specification limits. This can happen if the characteristic is set to a type that does not support USL.
  Characteristic Configuration: The characteristic may be incorrectly configured in the master data, leading to inconsistencies in how limits are applied.
  Quality Management Settings: The overall settings in the Quality Management module may not be aligned with the requirements for the specific characteristic.
  
  
  Solution:
  To resolve the QMIP_EA226 error, you can take the following steps:
  
  
  Check Control Indicators:
  
  Go to the characteristic