How To Fix QIE_SETUP050 - Insp. severity &1 from dyn.mod.rule &2 does not exist in samp. scheme &3

QIE_SETUP050 - Overview

• Message type: E = Error

• Message class: QIE_SETUP -

• Message number: 050

• Message text: Insp. severity &1 from dyn.mod.rule &2 does not exist in samp. scheme &3

What causes this issue?

The specified dynamic modification rule &V2& uses the inspection
severity &V1&. No sampling plans for this inspection severity exist in
the specified sampling scheme &V3&.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

To make the entries consistent, you must do the following:
Specify a sampling scheme that contains a sampling plan for the
inspection severity &V1& or add a corresponding sampling plan to the
sampling scheme &V3&.
Specify a dynamic modification rule that does not use the inspection
severity &V1&.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QIE_SETUP050 - Insp. severity &1 from dyn.mod.rule &2 does not exist in samp. scheme &3 ?

  The SAP error message QIE_SETUP050 indicates that there is an issue with the inspection severity defined in the dynamic modification rule (DMR) not existing in the specified sampling scheme. This error typically arises in the context of Quality Management (QM) in SAP, particularly when setting up inspection plans or sampling procedures.
  
  Cause:
  
  Missing Inspection Severity: The inspection severity specified in the dynamic modification rule does not exist in the sampling scheme. This could happen if the severity was deleted or never created.
  Incorrect Configuration: There may be a misconfiguration in the dynamic modification rules or the sampling scheme.
  Data Inconsistency: There could be inconsistencies in the data between the dynamic modification rules and the sampling scheme.
  
  
  Solution:
  
  
  Check Inspection Severity:
  
  Go to the sampling scheme configuration and verify that the inspection severity mentioned in the error message exists.
  If it does not exist, you may need to create it or adjust the dynamic modification rule to reference a