How To Fix QIE_SAMP_DRWP033 - Sample qty unit &1 not permitted for sample-drawing instr. of category &2

SAP Error Message - Details

• Message type: E = Error

• Message class: QIE_SAMP_DRWP - QIE Sample-Drawing Procedure

• Message number: 033

• Message text: Sample qty unit &1 not permitted for sample-drawing instr. of category &2

What causes this issue?

You must specify the sample quantity either for no sample-drawing
instructions or for all sample-drawing instructions of a sample-drawing
unit. If you specify more than one sample-drawing instruction for a
sample category (pooled sample or primary sample), all these
sample-drawing instructions must contain a sample quantity and the
sample quantities must have the same unit.
For sample category &V2&, a sample-drawing instruction already exists
with the unit &V3&, the unit of this sample-drawing instruction,
however, is &V1&. This unit is therefore not permitted.

System Response

The sample-drawing instruction is not created, changed, or deleted and
is not taken into account in sample calculation.

How to fix this error?

Make sure that the sample quantities and units of the sample quantities
meet the requirements.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QIE_SAMP_DRWP033 - Sample qty unit &1 not permitted for sample-drawing instr. of category &2 ?

  The SAP error message QIE_SAMP_DRWP033 indicates that there is an issue with the sample quantity unit specified in the sample-drawing instruction. Specifically, the error states that the sample quantity unit (&1) is not permitted for the sample-drawing instruction of the specified category (&2).
  
  Cause:
  
  Incorrect Unit of Measure: The sample quantity unit you are trying to use is not valid for the category of the sample-drawing instruction you are working with. Each category may have specific units of measure that are allowed.
  
  Configuration Issues: The configuration settings in the SAP system for sample-drawing instructions may not include the unit of measure you are trying to use.
  Data Entry Error: There may have been a mistake in entering the sample quantity unit in the relevant transaction or master data.
  
  
  Solution:
  
  Check Allowed Units: Verify the allowed units of measure for the sample-drawing instruction category you are using. You can do this by checking the configuration settings in