How To Fix QE723 - A histogram cannot be displayed for characteristic &1

SAP Error Message - Details

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 723

• Message text: A histogram cannot be displayed for characteristic &1

What causes this issue?

You wanted to display a <ZH>histogram</> for characteristic &V1&. To do
so, the following preconditions must be fulfilled:
The confirmation of <ZH>measured values</> must be supported.
<ZH>Individual results</> or <ZH>classed results</> must be supported.
At least one valid value must have already been recorded.

System Response

The function was not carried out.

How to fix this error?

Select a characteristic that fulfills the above preconditions.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE723 - A histogram cannot be displayed for characteristic &1 ?

  The SAP error message QE723, which states "A histogram cannot be displayed for characteristic &1," typically occurs in the context of Quality Management (QM) or other modules where histograms are used to analyze data related to characteristics.
  Cause:
  The error message QE723 can be triggered by several factors, including:
  
  
  Missing Data: The characteristic specified in the error message does not have any data associated with it. This could be due to a lack of recorded measurements or results for that characteristic.
  
  
  Incorrect Characteristic Configuration: The characteristic may not be properly configured in the system, or it may not be set up to allow for histogram generation.
  
  
  Data Type Issues: The characteristic may be of a data type that does not support histogram generation. For example, if the characteristic is a text field or a non-numeric field, a histogram cannot be created.
  
  
  Authorization Issues: The user may not have the necessary authorizations to view or generate histograms for the specified characteristic.
  
  
  System Configuration: There may be issues with the system configuration or settings that prevent the histogram from being generated.
  
  
  Solution:
  To resolve the QE723 error, you can take the following steps:
  
  
  Check Data Availability: Ensure that there is data available for the characteristic in question. You can do this by reviewing the relevant inspection lots or results.
  
  
  Review Characteristic Configuration: Verify that the characteristic is correctly configured in the system. Check the settings in the characteristic definition to ensure it is set up for histogram analysis.
  
  
  Data Type Verification: Confirm that the characteristic is of a numeric type that supports histogram generation. If it is not, consider using a different characteristic that is suitable for this purpose.
  
  
  User Authorizations: Check the user roles and authorizations to ensure that the user has the necessary permissions to access and generate histograms for the characteristic.
  
  
  System Settings: Consult with your SAP Basis or system administrator to review any system settings or configurations that may be affecting histogram generation.
  
  
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that may address this specific error or provide additional guidance.
  
  
  Related Information:
  
  SAP Documentation: Refer to the official SAP documentation for Quality Management and histogram generation for more detailed information on characteristics and their configurations.
  Transaction Codes: Familiarize yourself with relevant transaction codes such as QA32 (for inspection lot analysis) and QA11 (for recording results) to help troubleshoot the issue.
  Community Forums: Consider visiting SAP community forums or discussion boards where other users may have encountered similar issues and shared their solutions.
  
  By following these steps, you should be able to identify the cause of the QE723 error and implement an appropriate solution.