How To Fix QE708 - Track &2 for control chart type &1 does not exist

SAP Error Message - Details

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 708

• Message text: Track &2 for control chart type &1 does not exist

What causes this issue?

You have attempted to use track &V2& of the control chart type &V1&.
This track, however, does not exist or no longer exists.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the control chart type &V1& in the Customizing application and,
if necessary, define track &V2&. Then repeat the current operation.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE708 - Track &2 for control chart type &1 does not exist ?

  The SAP error message QE708 indicates that there is an issue with a control chart type that is being referenced in the Quality Management (QM) module. Specifically, the error message states that the control chart type specified does not exist for the given track.
  Cause:
  The error can occur due to several reasons:
  
  Non-existent Control Chart Type: The control chart type specified in the system does not exist or has not been defined in the system.
  Incorrect Configuration: The configuration for the control chart type may be incorrect or incomplete.
  Data Entry Error: There may be a typographical error in the control chart type or track number being referenced.
  Missing Authorization: The user may not have the necessary authorizations to access the control chart type.
  
  Solution:
  To resolve the QE708 error, you can take the following steps:
  
  
  Check Control Chart Type:
  
  Go to the transaction code QCC1 (Control Chart Type) to verify if the control chart type exists.
  If it does not exist, you may need to create it using the transaction code QCC1 or consult with your SAP QM administrator.
  
  
  
  Verify Track Number:
  
  Ensure that the track number referenced in the error message is correct and corresponds to a valid control chart type.
  
  
  
  Configuration Review:
  
  Review the configuration settings for the control chart type in the Quality Management module to ensure that all necessary parameters are set correctly.
  
  
  
  Check Authorizations:
  
  Ensure that the user has the necessary authorizations to access and use the control chart type. This may involve checking user roles and permissions.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for additional guidance on control chart types and their configuration.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting SAP Notes for any known issues related to this error.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  QCC1: Create Control Chart Type
  QCC2: Change Control Chart Type
  QCC3: Display Control Chart Type
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Quality Management Documentation: Review the SAP Help Portal for detailed information on Quality Management and control chart types.
  
  By following these steps, you should be able to identify and resolve the issue related to the QE708 error message in SAP.