How To Fix QE707 - SPC criterion &1 cannot be used

SAP Error Message - Details

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 707

• Message text: SPC criterion &1 cannot be used

What causes this issue?

The SPC criterion &V1& is incomplete and can therefore not be used.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

A function module for the determination of a quality control chart must
be created for SPC criterium &V1& in the configuration menu.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE707 - SPC criterion &1 cannot be used ?

  The SAP error message QE707, which states "SPC criterion &1 cannot be used," typically occurs in the context of Statistical Process Control (SPC) within the Quality Management (QM) module of SAP. This error indicates that the specified SPC criterion cannot be applied to the current context, often due to configuration or data issues.
  Causes:
  
  Invalid SPC Criterion: The SPC criterion specified may not be valid for the current quality inspection or may not be defined in the system.
  Missing Configuration: The SPC criterion may not be properly configured in the system, or it may not be assigned to the relevant quality inspection characteristics.
  Characteristic Type: The characteristic type may not support the specified SPC criterion.
  Data Issues: There may be issues with the data being analyzed, such as missing or incorrect entries.
  
  Solutions:
  
  
  Check SPC Criterion Configuration:
  
  Go to the configuration settings for SPC criteria in SAP (Transaction code: SPRO).
  Ensure that the SPC criterion you are trying to use is defined and correctly configured.
  
  
  
  Verify Characteristic Assignment:
  
  Check if the SPC criterion is assigned to the relevant quality inspection characteristics.
  Ensure that the characteristic type supports the SPC criterion.
  
  
  
  Review Inspection Plan:
  
  Review the inspection plan to ensure that the SPC criterion is correctly assigned to the inspection characteristics.
  Make any necessary adjustments to the inspection plan.
  
  
  
  Data Validation:
  
  Validate the data being used for the SPC analysis. Ensure that all required data is present and correctly formatted.
  Check for any missing or incorrect entries in the quality inspection results.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for more detailed information on the specific SPC criterion and its requirements.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  SPC in SAP QM: Statistical Process Control is a method used to monitor and control a process through the use of statistical methods. In SAP QM, it is used to ensure that processes remain stable and produce products that meet quality standards.
  Transaction Codes: Familiarize yourself with relevant transaction codes such as:
  
  SPRO: Customizing settings.
  QCC1: Create Quality Inspection Characteristics.
  QCC2: Change Quality Inspection Characteristics.
  
  
  SAP Notes: Check for any SAP Notes related to the QE707 error message for potential patches or updates that may resolve the issue.
  
  By following these steps, you should be able to identify the cause of the QE707 error and implement a solution to resolve it.