How To Fix QE430 - The smallest factor possible is &1

QE430 - Overview

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 430

• Message text: The smallest factor possible is &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE430 - The smallest factor possible is &1 ?

  The SAP error message QE430, which states "The smallest factor possible is &1," typically occurs in the context of quality management (QM) when dealing with inspection characteristics and sampling procedures. This error indicates that the system has encountered a situation where the specified factor for a sampling procedure is smaller than the minimum allowed value.
  
  Cause:
  The error is usually caused by one of the following reasons:
  
  Incorrect Sampling Procedure: The sampling procedure defined for the inspection lot may have a factor that is not valid or is set too low.
  
  Configuration Issues: The configuration settings for the quality management module may not be set up correctly, leading to invalid parameters being used.
  Data Entry Errors: There may be a mistake in the data entry for the inspection characteristics or sampling plans.
  
  
  Solution:
  To resolve the QE430 error, you can take the following steps:
  
  
  Check Sampling Procedure:
  
  Go to the sampling procedure configuration in SAP (Transaction code: QP03).
  Verify the