How To Fix QD032 - No corresponding sampling procedure was found

SAP Error Message - Details

• Message type: E = Error

• Message class: QD - Message-Id. für Dynamisierung

• Message number: 032

• Message text: No corresponding sampling procedure was found

What causes this issue?

Not all sampling procedures can be used in this situation.
Example:
Only the sampling procedures for an attributive inspection based on the
number of nonconforming units are allowed.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QD032 - No corresponding sampling procedure was found ?

  The SAP error message QD032 ("No corresponding sampling procedure was found") typically occurs in the context of quality management (QM) when a sampling procedure is required for a quality inspection but cannot be found in the system. This can happen during the creation of an inspection lot or when trying to perform a quality inspection.
  Causes:
  
  Missing Sampling Procedure: The most common cause is that the sampling procedure has not been defined for the material or inspection type in the system.
  Incorrect Configuration: The sampling procedure may not be correctly assigned to the material master or the inspection plan.
  Inactive Sampling Procedure: The sampling procedure might exist but is inactive or not valid for the specified criteria.
  Missing Master Data: The necessary master data (like material master or inspection plan) may not be set up correctly.
  Incorrect Inspection Type: The inspection type being used may not have a corresponding sampling procedure defined.
  
  Solutions:
  
  
  Define Sampling Procedure:
  
  Go to the transaction code Q/03 (or use the relevant menu path) to create or modify a sampling procedure.
  Ensure that the sampling procedure is defined correctly and is active.
  
  
  
  Assign Sampling Procedure:
  
  Check the material master (transaction code MM02) to ensure that the sampling procedure is assigned to the relevant material and inspection type.
  Navigate to the Quality Management view and verify the sampling procedure assignment.
  
  
  
  Check Inspection Plan:
  
  Use transaction code QP01 to check the inspection plan for the material. Ensure that the sampling procedure is linked to the inspection characteristics.
  
  
  
  Review Configuration:
  
  If you have access, review the configuration settings in the Quality Management module to ensure that the sampling procedures are set up correctly.
  Use transaction code SPRO to access the configuration settings and navigate to Quality Management settings.
  
  
  
  Consult Documentation:
  
  If you are unsure about the correct sampling procedure to use, consult your organization's documentation or reach out to your SAP QM consultant for guidance.
  
  
  
  Testing:
  
  After making changes, test the process again to ensure that the error does not occur.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  Q/03: Create/Change Sampling Procedure
  MM02: Change Material Master
  QP01: Create Inspection Plan
  SPRO: Customizing (Configuration)
  
  
  
  SAP Notes: Check SAP Notes for any known issues or updates related to this error message. You can search for relevant notes in the SAP Support Portal.
  
  
  User Roles: Ensure that you have the necessary authorizations to make changes to the sampling procedures and related master data.
  
  
  By following these steps, you should be able to resolve the QD032 error and ensure that the appropriate sampling procedures are in place for your quality inspections.