How To Fix QAM260 - Mapping type for object type &1 is not ID mapping

SAP Error Message - Details

• Message type: E = Error

• Message class: QAM - General Message Class for Quality Issue Management

• Message number: 260

• Message text: Mapping type for object type &1 is not ID mapping

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message QAM260 - Mapping type for object type &1 is not ID mapping ?

  The SAP error message QAM260 indicates that there is an issue with the mapping type for a specific object type in the Quality Management (QM) module. The message states that the mapping type for the specified object type (&1) is not set to ID mapping, which is required for the operation you are trying to perform.
  Cause:
  The error typically arises due to one of the following reasons:
  
  Incorrect Mapping Configuration: The mapping type for the object type in question is not configured correctly in the system. This could be due to a misconfiguration in the Quality Management settings.
  Object Type Not Supported: The object type you are trying to use may not support ID mapping, or it may not be set up to use ID mapping in the system.
  Missing or Incomplete Customization: The necessary customization for the object type may not have been completed, leading to the system not recognizing it as an ID mapping type.
  
  Solution:
  To resolve the QAM260 error, you can take the following steps:
  
  
  Check Mapping Configuration:
  
  Go to the configuration settings for Quality Management in SAP.
  Navigate to the relevant area where object types and their mapping types are defined.
  Verify that the mapping type for the object type (&1) is set to ID mapping.
  
  
  
  Adjust Object Type Settings:
  
  If the object type is not set to ID mapping, you may need to change the settings to ensure it is configured correctly.
  Consult with your SAP administrator or a functional consultant to make the necessary adjustments.
  
  
  
  Review Documentation:
  
  Check SAP documentation or help resources for specific instructions on how to configure mapping types for the object type in question.
  
  
  
  Testing:
  
  After making changes, perform a test to ensure that the error no longer occurs and that the system behaves as expected.
  
  
  
  Consult SAP Support:
  
  If you are unable to resolve the issue through configuration changes, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO to access the configuration settings for Quality Management.
  Object Types: Familiarize yourself with the specific object types used in your QM processes, as this will help in understanding the mapping requirements.
  SAP Notes: Look for relevant SAP Notes that may address this specific error or provide additional guidance on configuration.
  
  By following these steps, you should be able to identify and resolve the cause of the QAM260 error in your SAP system.