How To Fix Q0212 - You cannot valuate according to number of defects and selected sets

SAP Error Message - Details

• Message type: E = Error

• Message class: Q0 - QM: Generally valid messages

• Message number: 212

• Message text: You cannot valuate according to number of defects and selected sets

What causes this issue?

The indicators for valuation according to the number of defects and
valuation according to the selected set are both set. These two
indicators cannot be set concurrently.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

You must decide whether you want to inspect using selected sets or
whether you want to valuate using the number of defects.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message Q0212 - You cannot valuate according to number of defects and selected sets ?

  The SAP error message Q0212, "You cannot valuate according to number of defects and selected sets," typically occurs in the context of quality management (QM) when you are trying to perform a valuation based on the number of defects in a quality inspection lot, but the system is unable to process this request due to certain conditions not being met.
  Cause:
  
  Incompatible Valuation Method: The valuation method you are trying to use may not be compatible with the selected sets or the data in the inspection lot.
  Missing Configuration: The configuration for the valuation method may not be set up correctly in the system.
  Data Issues: There may be issues with the data in the inspection lot, such as missing defect records or incorrect settings.
  Selected Sets: The selected sets you are trying to use may not be defined properly or may not correspond to the defects recorded.
  
  Solution:
  
  Check Valuation Method: Ensure that the valuation method you are using is appropriate for the inspection lot and the defects recorded. You may need to change the valuation method to one that is compatible.
  Review Configuration: Go to the configuration settings in SAP (transaction code SPRO) and check the settings for quality management and valuation methods. Ensure that everything is set up correctly.
  Inspect Data: Review the inspection lot data to ensure that all necessary defect records are present and correctly entered. Check for any inconsistencies or missing information.
  Validate Selected Sets: Ensure that the selected sets you are using are correctly defined and correspond to the defects you are trying to evaluate. You may need to create or modify selected sets to align with your requirements.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the valuation methods and selected sets in your version of SAP.
  
  Related Information:
  
  Transaction Codes: You may find it helpful to use transaction codes such as QA32 (for displaying inspection lots) or QA11 (for recording results) to review the inspection lots and their associated defects.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a technical consultant who specializes in SAP QM for further assistance.