How To Fix PYC_CONF022 - Process start of recurrence &1 must be no greater than process end

SAP Error Message - Details

• Message type: E = Error

• Message class: PYC_CONF - Payroll Control Center Configuration

• Message number: 022

• Message text: Process start of recurrence &1 must be no greater than process end

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PYC_CONF022 - Process start of recurrence &1 must be no greater than process end ?

  The SAP error message PYC_CONF022 indicates that there is an issue with the configuration of a recurring process in the SAP system. Specifically, the error states that the start time of a recurrence must not be greater than the end time of that same recurrence. This typically occurs in the context of planning or scheduling processes, such as in SAP's Project System (PS) or Controlling (CO) modules.
  Cause:
  The error is caused by a misconfiguration in the recurrence settings of a process. This can happen if:
  
  The start date/time for a recurring process is set later than the end date/time.
  There is a logical error in the input data where the recurrence intervals overlap incorrectly.
  
  Solution:
  To resolve this error, you should:
  
  Check Recurrence Settings: Go to the configuration or settings for the recurring process that is generating the error. Verify the start and end times.
  Adjust Dates/Times: Ensure that the start time is earlier than the end time. If necessary, modify the recurrence settings to correct the timing.
  Validate Input Data: If the recurrence is based on user input or data from another source, validate that the data is correct and does not contain any errors.
  Test Changes: After making adjustments, test the process again to ensure that the error no longer occurs.
  
  Related Information:
  
  Transaction Codes: Depending on the module you are working with, you may need to use specific transaction codes to access the configuration settings (e.g., CJ20N for Project System).
  Documentation: Refer to SAP documentation or help files related to the specific module you are using for more detailed guidance on configuring recurrences.
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that may address this error or provide additional troubleshooting steps.
  
  If the issue persists after following these steps, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.