How To Fix PPECHK408 - Mode &1 is not assigned to alternative work center &2 (line balance &3)

SAP Error Message - Details

• Message type: E = Error

• Message class: PPECHK - iPPE Consistency Check

• Message number: 408

• Message text: Mode &1 is not assigned to alternative work center &2 (line balance &3)

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPECHK408 - Mode &1 is not assigned to alternative work center &2 (line balance &3) ?

  The SAP error message PPECHK408 indicates that a specific mode is not assigned to the alternative work center in the context of line balancing. This error typically arises in the Production Planning and Execution (PP/PE) module when there is an inconsistency in the configuration of work centers and modes.
  Cause:
  
  Missing Assignment: The mode specified in the error message is not assigned to the alternative work center. This can happen if the work center configuration is incomplete or if the mode was not properly set up.
  Incorrect Configuration: The work center may not have the necessary modes defined, or the alternative work center may not be correctly linked to the production process.
  Data Inconsistency: There may be inconsistencies in the master data related to work centers, modes, or line balancing.
  
  Solution:
  
  
  Check Work Center Configuration:
  
  Go to the work center configuration in SAP (Transaction code: CR01 or CR02).
  Verify that the alternative work center is correctly defined and that the required mode is assigned to it.
  
  
  
  Assign Mode to Work Center:
  
  If the mode is missing, you need to assign it to the alternative work center. This can be done in the work center settings under the "Capacity" tab.
  Ensure that the mode is correctly defined and linked to the work center.
  
  
  
  Review Line Balancing Settings:
  
  Check the line balancing settings to ensure that the correct work centers and modes are being used.
  Make sure that the line balance is correctly configured to utilize the alternative work center.
  
  
  
  Data Consistency Check:
  
  Run a consistency check on the master data to identify any discrepancies that may be causing the error.
  Correct any inconsistencies found during the check.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on configuring work centers and modes.
  
  
  
  Related Information:
  
  Transaction Codes: CR01 (Create Work Center), CR02 (Change Work Center), CR03 (Display Work Center).
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide additional guidance on this error.
  User Roles: Ensure that you have the necessary permissions to make changes to work center configurations.
  
  By following these steps, you should be able to resolve the PPECHK408 error and ensure that the modes are correctly assigned to the alternative work centers in your SAP system.