How To Fix PPEARCHCMP107 - &1 &2 is used in &3 &4

PPEARCHCMP107 - Overview

• Message type: E = Error

• Message class: PPEARCHCMP - iPPE Archiving Components

• Message number: 107

• Message text: &1 &2 is used in &3 &4

What causes this issue?

The &V1& &V2& cannot be deleted because the higher-level &V3& &V4& is
still being used.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPEARCHCMP107 - &1 &2 is used in &3 &4 ?

  The SAP error message PPEARCHCMP107 typically indicates that a certain component or object (like a characteristic or a key figure) is being used in a context where it cannot be used, such as in a planning area or a planning object. The placeholders &1, &2, &3, and &4 in the error message will be replaced with specific values that provide more context about the error.
  
  Cause:
  The error usually arises when:
  
  A characteristic or key figure is being referenced in a planning area or planning object where it is not allowed.
  There may be inconsistencies in the configuration of the planning area or the data model.
  The object might be locked or not properly defined in the system.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Configuration:
  
  Review the configuration of the planning area or object in question. Ensure that the characteristic or key figure is correctly defined and is allowed to be used