How To Fix PPEACT111 - The object dependency at &1 &2 is not active

PPEACT111 - Overview

• Message type: E = Error

• Message class: PPEACT - Messages for iPPE ACT Application (Activities)

• Message number: 111

• Message text: The object dependency at &1 &2 is not active

What causes this issue?

The object dependency at &V1& &V2& is not active.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Correct the object dependency that was maintained at &V1& &V2& to set
the status to active.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPEACT111 - The object dependency at &1 &2 is not active ?

  The SAP error message PPEACT111 indicates that an object dependency (such as a variant configuration dependency) is not active in the system. This can occur in the context of variant configuration where dependencies are used to control the behavior of configurable materials.
  
  Cause:
  The error typically arises due to one of the following reasons:
  
  Inactive Object Dependency: The specific object dependency (e.g., a class, characteristic, or dependency) has not been activated in the system.
  Missing Activation: The object dependency may have been created but not activated, or it may have been deactivated after being previously active.
  Transport Issues: If the object dependency was transported from another system, it may not have been activated in the target system.
  
  
  Solution:
  To resolve the error, you can follow these steps:
  
  
  Activate the Object Dependency:
  
  Go to the transaction code CU02 (Change Object Dependencies) or CU01 (Create Object Dependencies).
  Enter the object dependency name and check its status.
  If it is inactive, activate it.
  
  
  
  Check for