How To Fix PO333 - OTF module: Page buffer (&1 entries) is too small

SAP Error Message - Details

• Message type: E = Error

• Message class: PO - Spooler message

• Message number: 333

• Message text: OTF module: Page buffer (&1 entries) is too small

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PO333 - OTF module: Page buffer (&1 entries) is too small ?

  The SAP error message PO333 indicates that the page buffer for the OTF (Output Text Format) module is too small to accommodate the number of entries being processed. This typically occurs when generating output documents, such as print layouts or forms, where the data being processed exceeds the allocated buffer size.
  Cause:
  The error is caused by the OTF page buffer being insufficient to hold all the entries required for the output. This can happen due to:
  
  A large volume of data being processed for printing or output.
  Complex forms or layouts that require more space than the default buffer size allows.
  Configuration settings that do not match the requirements of the output being generated.
  
  Solution:
  To resolve the PO333 error, you can take the following steps:
  
  
  Increase the OTF Buffer Size:
  
  You can increase the size of the OTF buffer in the SAP system. This is typically done by adjusting the parameter otf/size in the SAP profile parameters.
  Use transaction RZ10 to change the instance profile or the default profile.
  Add or modify the parameter:
  otf/size = <new_size>
  Replace <new_size> with a larger value (e.g., 1000000 for 1 million bytes).
  
  
  
  
  Check the Output Device Configuration:
  
  Ensure that the output device settings are correctly configured. Sometimes, the device settings can limit the buffer size.
  Use transaction SPAD to check and modify the output device settings.
  
  
  
  Optimize the Form Layout:
  
  If possible, simplify the form layout or reduce the amount of data being processed in a single output request. This can help in fitting the data within the existing buffer size.
  
  
  
  Test the Changes:
  
  After making changes to the buffer size or form layout, test the output generation again to see if the error persists.
  
  
  
  Consult SAP Notes:
  
  Check for any relevant SAP Notes that may provide additional guidance or patches related to this error. You can search for notes in the SAP Support Portal.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  RZ10: To change profile parameters.
  SPAD: To manage output devices.
  
  
  
  SAP Documentation:
  
  Refer to the SAP Help Portal for documentation on OTF processing and output management.
  
  
  
  Performance Considerations:
  
  Increasing the buffer size may have implications on system performance, so monitor the system after making changes.
  
  
  
  By following these steps, you should be able to resolve the PO333 error and successfully generate the required output.