How To Fix /PLMI/DIR_BRW_BO029 - Source structure(s) are created in CAD; checkbox is not set in target

SAP Error Message - Details

• Message type: E = Error

• Message class: /PLMI/DIR_BRW_BO -

• Message number: 029

• Message text: Source structure(s) are created in CAD; checkbox is not set in target

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /PLMI/DIR_BRW_BO029 - Source structure(s) are created in CAD; checkbox is not set in target ?

  The SAP error message /PLMI/DIR_BRW_BO029 indicates that there is a mismatch between the source and target structures in the context of a CAD (Computer-Aided Design) integration scenario. Specifically, it suggests that the source structure(s) have been created in CAD, but the corresponding checkbox in the target system is not set, which is likely preventing the proper transfer or synchronization of data.
  Cause:
  
  Checkbox Not Set: The error typically arises when the checkbox related to the integration of CAD structures is not activated in the target system. This checkbox is usually found in the configuration settings for the relevant data transfer or integration process.
  Configuration Issues: There may be a misconfiguration in the settings for the integration between the CAD system and SAP, leading to this error.
  Data Transfer Settings: The settings for data transfer from CAD to SAP might not be correctly defined, causing the system to reject the structures created in CAD.
  
  Solution:
  
  
  Check Configuration Settings:
  
  Navigate to the relevant configuration area in SAP where the integration settings are defined.
  Look for the checkbox that pertains to the acceptance of CAD structures. Ensure that it is checked/enabled.
  
  
  
  Review Data Transfer Settings:
  
  Verify the data transfer settings between the CAD system and SAP. Ensure that all necessary parameters are correctly set up to allow for the transfer of CAD structures.
  
  
  
  Consult Documentation:
  
  Refer to the SAP documentation or help resources related to CAD integration. This may provide specific guidance on the settings and configurations required.
  
  
  
  Testing:
  
  After making the necessary changes, perform a test to ensure that the structures can now be transferred without encountering the error.
  
  
  
  Contact Support:
  
  If the issue persists after checking the configurations and settings, consider reaching out to SAP support or your internal IT team for further assistance.
  
  
  
  Related Information:
  
  Integration Scenarios: Understanding the specific integration scenario between your CAD system and SAP can provide insights into the required configurations.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Forums: Engaging with user forums or communities focused on SAP and CAD integration can also yield helpful advice and solutions from other users who may have encountered similar issues.
  
  By following these steps, you should be able to resolve the error message and ensure proper integration between your CAD system and SAP.