How To Fix PLM_FMEA_APPL603 - Position &1 is not permitted for risk matrix &2

PLM_FMEA_APPL603 - Overview

• Message type: E = Error

• Message class: PLM_FMEA_APPL - FMEA - Message

• Message number: 603

• Message text: Position &1 is not permitted for risk matrix &2

What causes this issue?

The position you specified for the risk matrix is not permitted.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

The position that is permitted for a risk matrix depends on the selected
width of the risk matrix and the number of risk matrixes in the view.
The following combinations are permitted in a view:
3 risk matrixes:
The risk matrixes must be <ZK>narrow</>. Place one risk matrix each on
the left, in the center, and on the right.
2 risk matrixes:
One risk matrix must be <ZK>narrow</> and the other <ZK>wide</>. Place
one risk matrix each to the left and to the right.
1 risk matrix:
The risk matrix is automatically displayed as <ZK>very wide</>.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PLM_FMEA_APPL603 - Position &1 is not permitted for risk matrix &2 ?

  The SAP error message PLM_FMEA_APPL603 indicates that there is an issue with the configuration of the risk matrix in the context of Failure Mode and Effects Analysis (FMEA) within the SAP PLM (Product Lifecycle Management) module. Specifically, the error states that a certain position (or level) is not permitted for the specified risk matrix.
  
  Cause:
  
  Configuration Issue: The risk matrix may not be properly configured to allow the specified position. This could be due to incorrect settings in the risk matrix configuration.
  Position Not Defined: The position you are trying to use may not be defined in the risk matrix settings.
  Incompatibility: The position may not be compatible with the risk matrix due to the defined criteria or thresholds.
  
  
  Solution:
  
  
  Check Risk Matrix Configuration:
  
  Navigate to the configuration settings for the risk matrix in SAP.
  Verify that the position you are trying to use is included in the risk matrix settings.
  Ensure that the risk matrix is correctly set