How To Fix PLM_FMEA_APPL602 - Width &1 is not permitted for risk matrix &2

PLM_FMEA_APPL602 - Overview

• Message type: E = Error

• Message class: PLM_FMEA_APPL - FMEA - Message

• Message number: 602

• Message text: Width &1 is not permitted for risk matrix &2

What causes this issue?

The width you selected for the risk matrix is not permitted.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

The width permitted for a risk matrix depends on the number of risk
matrixes in the view. The following combinations are permitted in a
view:
3 risk matrixes:
The risk matrixes must be <ZK>narrow</>. Place one risk matrix each on
the left, in the center, and on the right.
2 risk matrixes:
One risk matrix must be <ZK>narrow</> and the other <ZK>wide</>. Place
one risk matrix each to the left and to the right.
1 risk matrix:
The risk matrix is automatically displayed as <ZK>very wide</>.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PLM_FMEA_APPL602 - Width &1 is not permitted for risk matrix &2 ?

  The SAP error message PLM_FMEA_APPL602, which states "Width &1 is not permitted for risk matrix &2," typically occurs in the context of the FMEA (Failure Mode and Effects Analysis) module within SAP PLM (Product Lifecycle Management). This error indicates that the specified width for a risk matrix does not conform to the allowed settings defined in the system.
  
  Cause:
  
  Invalid Width Configuration: The width specified for the risk matrix (e.g., the number of columns or the range of values) is not within the permissible limits set in the configuration of the risk matrix.
  Matrix Definition Issues: The risk matrix may not be properly defined or configured in the system, leading to inconsistencies when trying to use it.
  Data Entry Error: There may be a mistake in the data entry where the width value is incorrectly specified.
  
  
  Solution:
  
  
  Check Risk Matrix Configuration:
  
  Navigate to the configuration settings for the risk matrix in SAP PLM.
  Verify the defined width for