How To Fix PG148 - Number for wage type & is too low (table T511)

SAP Error Message - Details

• Message type: E = Error

• Message class: PG - Error Messages for Master Data Programs

• Message number: 148

• Message text: Number for wage type & is too low (table T511)

What causes this issue?

The number you have entered is lower than the minimum specified for
the wage type.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the entry and setting for this wage type in the "Wage Type
Characteristics" view (V_T511).

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PG148 - Number for wage type & is too low (table T511) ?

  The SAP error message PG148, which states "Number for wage type & is too low (table T511)," typically occurs when there is an issue with the configuration of wage types in the SAP system. This error indicates that the wage type being referenced has a number that is below the minimum allowed value defined in the system.
  Cause:
  
  Wage Type Configuration: The wage type in question may have been incorrectly configured in the T511 table, which is used to define wage types and their characteristics.
  Invalid Wage Type: The wage type being used in the payroll process may not be valid or may not exist in the T511 table.
  Data Entry Error: There may be a data entry error where a wage type number has been entered incorrectly in the payroll or personnel administration infotype.
  Custom Development: If there are custom developments or enhancements in the payroll process, they may be referencing an incorrect wage type.
  
  Solution:
  
  
  Check T511 Table: 
  
  Go to transaction code SE11 (Data Dictionary) and check the T511 table to ensure that the wage type in question exists and is configured correctly.
  Verify that the wage type has a valid number and that it meets the minimum requirements set in the system.
  
  
  
  Review Wage Type Configuration:
  
  Use transaction code PE01 to review the configuration of the wage type. Ensure that all necessary settings are correctly defined.
  Check if the wage type is marked as active and is assigned to the correct payroll area.
  
  
  
  Correct Data Entry:
  
  Review the infotypes (such as IT0008 for Basic Pay) where the wage type is being used. Ensure that the wage type is entered correctly and that there are no typos or incorrect values.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to wage type configuration for any specific guidelines or requirements.
  
  
  
  Testing:
  
  After making any changes, perform a test run of the payroll process to ensure that the error is resolved.
  
  
  
  Seek Help from SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Wage Type: A wage type is a classification of payments or deductions in payroll processing. Each wage type has specific characteristics and is used to calculate employee compensation.
  T511 Table: This table contains the definitions and configurations for wage types, including their characteristics, calculation rules, and other relevant data.
  Transaction Codes: Familiarize yourself with relevant transaction codes such as PE01 (Wage Type Configuration), SE11 (Data Dictionary), and PA20 (Display HR Master Data) for troubleshooting.
  
  By following these steps, you should be able to identify and resolve the issue related to the PG148 error message in SAP.