How To Fix OT769 - Parameter &1 has not been defined in Customizing for IDB

OT769 - Overview

• Message type: E = Error

• Message class: OT - SAP Online Correction Support (SOCS)

• Message number: 769

• Message text: Parameter &1 has not been defined in Customizing for IDB

What causes this issue?

Parameter &V1& in Customizing for the info DB should be read for the
check-in process.

System Response

Category &V1&, however, has not been defined.

How to fix this error?

Define parameter &V1& in the database table INFIDBSYS.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OT769 - Parameter &1 has not been defined in Customizing for IDB ?

  The SAP error message OT769, which states "Parameter &1 has not been defined in Customizing for IDB," typically occurs in the context of the Integrated Data Base (IDB) in SAP systems. This error indicates that a specific parameter, referenced by &1, is missing or not properly configured in the system's Customizing settings.
  
  Cause:
  The error is usually caused by one of the following reasons:
  
  Missing Configuration: The parameter that is referenced in the error message has not been defined in the Customizing settings for the IDB.
  Incorrect Customizing: The parameter may have been incorrectly configured or deleted.
  Transport Issues: If the configuration was transported from another system, it may not have been included or may have failed during the transport process.
  
  
  Solution:
  To resolve the OT769 error, follow these steps:
  
  
  Check Customizing Settings:
  
  Go to the Customizing transaction (SPRO).
  Navigate to the relevant section for IDB configuration.
  Look for the parameter mentioned in the error message (replace &1 with the actual