How To Fix OC280 - Tank assignment only possible for measurement point with type &.

SAP Error Message - Details

• Message type: E = Error

• Message class: OC - IS-Oil: BDRP Bulk Distribution Requirement Planning messages

• Message number: 280

• Message text: Tank assignment only possible for measurement point with type &.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message OC280 - Tank assignment only possible for measurement point with type &. ?

  The SAP error message OC280, which states "Tank assignment only possible for measurement point with type &," typically occurs in the context of managing tank measurements and assignments in SAP's Plant Maintenance (PM) or Materials Management (MM) modules. This error indicates that the system is trying to assign a tank to a measurement point that does not have the correct type defined.
  
  Cause:
  The error is caused by one of the following reasons:
  
  Incorrect Measurement Point Type: The measurement point you are trying to assign the tank to is not configured to accept tank assignments. Measurement points have different types (e.g., for flow, level, temperature, etc.), and only specific types are allowed for tank assignments.
  
  Configuration Issues: The configuration settings in the system may not be set up correctly to allow for tank assignments to the selected measurement point.
  Data Entry Error: There may be a mistake in the data entry where the wrong measurement