How To Fix MW211 - Error occurred rounding off qty to unit &

SAP Error Message - Details

• Message type: E = Error

• Message class: MW - Messages IS-R / Allocation Tables

• Message number: 211

• Message text: Error occurred rounding off qty to unit &

What causes this issue?

The system attempted to round off a quantity to the number of decimal
points defined for the unit of measure (&V1&). An error occurred.

System Response

INCLUDE ISR_VERARBEITUNG

How to fix this error?

INCLUDE ISR_SYSTEMFEHLER

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MW211 - Error occurred rounding off qty to unit & ?

  The SAP error message MW211, which states "Error occurred rounding off qty to unit &," typically occurs during inventory management or when processing goods movements. This error is related to issues with quantity rounding when converting between different units of measure (UoM) in SAP.
  Causes:
  
  Unit of Measure Configuration: The error may arise if the unit of measure settings for the material are not correctly configured. This includes the base unit of measure and any alternative units of measure.
  Decimal Places: The number of decimal places defined for the unit of measure may not be sufficient to handle the quantity being processed, leading to rounding issues.
  Quantity Conversion: If the system is trying to convert quantities between different units of measure and the conversion factor is not set up correctly, it can lead to rounding errors.
  Material Master Data: Issues in the material master data, such as incorrect settings for the unit of measure or rounding rules, can also trigger this error.
  
  Solutions:
  
  
  Check Unit of Measure Settings:
  
  Go to the material master (transaction code MM03) and check the unit of measure settings. Ensure that the base unit of measure and any alternative units are correctly defined.
  Verify the conversion factors between different units of measure.
  
  
  
  Adjust Decimal Places:
  
  Review the decimal places defined for the unit of measure in the configuration (transaction code OME1). Ensure that the decimal places are sufficient for the quantities being processed.
  
  
  
  Review Material Master Data:
  
  Check the material master data for any inconsistencies or errors. Ensure that the rounding rules and other relevant settings are correctly configured.
  
  
  
  Test with Different Quantities:
  
  If possible, test the transaction with different quantities to see if the error persists. This can help identify if the issue is related to specific quantities or general configuration.
  
  
  
  Consult SAP Notes:
  
  Check the SAP Support Portal for any relevant SAP Notes that may address this specific error. There may be patches or updates that resolve known issues.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. Provide them with detailed information about the error, including the transaction code and any relevant data.
  
  
  
  Related Information:
  
  Transaction Codes: MM03 (Display Material), OME1 (Maintain Units of Measure).
  SAP Documentation: Review SAP Help documentation for inventory management and unit of measure handling.
  User Forums: Check SAP community forums or user groups for discussions related to MW211 and similar issues.
  
  By following these steps, you should be able to identify and resolve the MW211 error in SAP.