How To Fix MFLOW020 - The produced quantity &1 &2 for order &3 was rounded up.

MFLOW020 - Overview

• Message type: E = Error

• Message class: MFLOW - Messages for Message Destination PI_MFLOW (PP-PI)

• Message number: 020

• Message text: The produced quantity &1 &2 for order &3 was rounded up.

What causes this issue?

As specified in the Customizing settings for the unit of measurement,
the system rounds up the produced quantity &1 &2 for order &3.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MFLOW020 - The produced quantity &1 &2 for order &3 was rounded up. ?

  The SAP error message MFLOW020 indicates that the produced quantity for a production order has been rounded up. This typically occurs in the context of production planning and execution, where the system rounds the quantity produced to meet certain constraints or requirements.
  
  Cause:
  
  Rounding Rules: The rounding behavior is often defined in the material master or production order settings. If the produced quantity does not meet the minimum lot size or is not a multiple of the rounding value, the system may round it up.
  Configuration Settings: The configuration settings in the production planning module (PP) or material management (MM) may dictate how quantities are rounded.
  Production Order Settings: The specific production order may have settings that lead to rounding, such as the defined unit of measure or the production version used.
  
  
  Solution:
  
  Check Material Master Settings: Review the material master data for the product in question. Look for the rounding profile and minimum lot size