How To Fix LTR2_SCN_CHECK_CM006 - Namespace &1 conflicts with namespace of the scenario; see long text

SAP Error Message - Details

• Message type: E = Error

• Message class: LTR2_SCN_CHECK_CM - LTR2 Checks on Content Modules of Scenario

• Message number: 006

• Message text: Namespace &1 conflicts with namespace of the scenario; see long text

What causes this issue?

If the namespace of the scenario is SAP, then namespace of the content
module can only be SAP.
If the namespace of the scenario is SAPPROJ, then namespace of the
content module can be SAP or SAPPROJ.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Remove the content module whose namespace conflicts with the namespace
of the scenario.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTR2_SCN_CHECK_CM006 - Namespace &1 conflicts with namespace of the scenario; see long text ?

  The SAP error message LTR2_SCN_CHECK_CM006 typically indicates a conflict between namespaces in a scenario, particularly when working with SAP Landscape Transformation (SLT) or related data replication scenarios. This error arises when the namespace of the object you are trying to create or modify does not match the expected namespace for the scenario.
  Cause:
  
  Namespace Conflict: The error occurs when the namespace of the object (like a table, function module, or other development objects) does not align with the namespace defined for the scenario in SLT.
  Incorrect Configuration: The configuration of the SLT scenario may have been set up incorrectly, leading to mismatches in expected namespaces.
  Development Objects: If you are trying to use custom development objects that are not in the correct namespace, this can trigger the error.
  
  Solution:
  
  
  Check Namespace Configuration:
  
  Verify the namespace settings in the SLT configuration. Ensure that the namespaces for the objects you are working with match the expected namespaces for the scenario.
  You can check the namespace settings in the SLT configuration transaction (usually in the SLT configuration settings).
  
  
  
  Adjust Object Namespaces:
  
  If you have custom objects, consider moving them to the correct namespace or adjusting their naming conventions to align with the scenario's requirements.
  
  
  
  Review Scenario Settings:
  
  Go through the settings of the SLT scenario to ensure that all configurations are correct and that there are no discrepancies in the namespaces.
  
  
  
  Consult Documentation:
  
  Refer to the SAP documentation for SLT and the specific scenario you are working with. This can provide insights into the expected configurations and namespaces.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the configurations, consider reaching out to SAP support for further assistance. They can provide more detailed guidance based on your specific setup.
  
  
  
  Related Information:
  
  SLT Documentation: Review the official SAP documentation for Landscape Transformation to understand the configuration and namespace requirements.
  Transaction Codes: Familiarize yourself with relevant transaction codes such as LTRC (for SLT configuration) and SLT monitoring tools.
  Namespace Guidelines: Understand the guidelines for naming conventions and namespaces in SAP development to avoid similar issues in the future.
  
  By following these steps, you should be able to resolve the namespace conflict and eliminate the error message.