How To Fix KX785 - &1 and &2 must refer to same characteristic

SAP Error Message - Details

• Message type: E = Error

• Message class: KX - EC-EIS/EC-BP: Data basis, data collection

• Message number: 785

• Message text: &1 and &2 must refer to same characteristic

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message KX785 - &1 and &2 must refer to same characteristic ?

  The SAP error message KX785 indicates that there is a mismatch between two characteristics in a configuration or a master data setup. Specifically, it states that the two characteristics referenced (denoted as &1 and &2) must refer to the same characteristic, which typically occurs in the context of variant configuration or when defining characteristics in a material master.
  Cause:
  
  Inconsistent Configuration: The error usually arises when there are inconsistencies in the configuration of characteristics. For example, if you are trying to assign two different characteristics to the same object or if there is a misconfiguration in the variant configuration settings.
  Incorrect Assignment: It can also occur if you are trying to use two different characteristics in a context where SAP expects them to be the same, such as in a dependency or a selection condition.
  
  Solution:
  
  Check Characteristic Assignments: Review the characteristics assigned to the material or configuration. Ensure that the characteristics you are trying to use are correctly defined and that they refer to the same characteristic where required.
  Correct Dependencies: If you are using dependencies in variant configuration, check the logic and ensure that the characteristics used in the dependencies are consistent and correctly referenced.
  Review Configuration Profiles: If applicable, check the configuration profiles and ensure that the characteristics are set up correctly and consistently across all relevant areas.
  Use the Same Characteristic: If the error indicates that two characteristics must be the same, modify your configuration to use the same characteristic in both places as required by the business logic.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CU50 (Configuration Profile) or CT04 (Characteristic) to review and modify characteristics and their assignments.
  Documentation: Refer to SAP documentation or help resources for detailed guidance on variant configuration and characteristic management.
  SAP Notes: Check for any relevant SAP Notes that might address specific issues related to this error message or provide additional troubleshooting steps.
  
  If the problem persists after checking these areas, it may be beneficial to consult with an SAP functional consultant who specializes in the relevant module (e.g., SD, MM, or PP) for further assistance.